lkml.org 
[lkml]   [2020]   [Jan]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH] ARM: dts: bcm283x: Unify CMA configuration
Date
On Fri, 10 Jan 2020 18:29:35 +0100, Nicolas Saenz Julienne <nsaenzjulienne@suse.de> wrote:
> With the introduction of the Raspberry Pi 4 we were forced to explicitly
> configure CMA's location, since arm64 defaults it into the ZONE_DMA32
> memory area, which is not good enough to perform DMA operations on that
> device. To bypass this limitation a dedicated CMA DT node was created,
> explicitly indicating the acceptable memory range and size.
>
> That said, compatibility between boards is a must on the Raspberry Pi
> ecosystem so this creates a common CMA DT node so as for DT overlays to
> be able to update CMA's properties regardless of the board being used.
>
> Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@suse.de>
> ---

Applied to devicetree/next, thanks!
--
Florian

\
 
 \ /
  Last update: 2020-01-16 00:41    [W:0.067 / U:0.888 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site