lkml.org 
[lkml]   [2019]   [Sep]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] net/skbuff: silence warnings under memory pressure
On Wed 04-09-19 16:00:42, Sergey Senozhatsky wrote:
> On (09/04/19 15:41), Sergey Senozhatsky wrote:
> > But the thing is different in case of dump_stack() + show_mem() +
> > some other output. Because now we ratelimit not a single printk() line,
> > but hundreds of them. The ratelimit becomes - 10 * $$$ lines in 5 seconds
> > (IOW, now we talk about thousands of lines).
>
> And on devices with slow serial consoles this can be somewhat close to
> "no ratelimit". *Suppose* that warn_alloc() adds 700 lines each time.
> Within 5 seconds we can call warn_alloc() 10 times, which will add 7000
> lines to the logbuf. If printk() can evict only 6000 lines in 5 seconds
> then we have a growing number of pending logbuf messages.

Yes, ratelimit is problematic when the ratelimited operation is slow. I
guess that is a well known problem and we would need to rework both the
api and the implementation to make it work in those cases as well.
Essentially we need to make the ratelimit act as a gatekeeper to an
operation section - something like a critical section except you can
tolerate more code executions but not too many. So effectively

start_throttle(rate, number);
/* here goes your operation */
end_throttle();

one operation is not considered done until the whole section ends.
Or something along those lines.

In this particular case we can increase the rate limit parameters of
course but I think that longterm we need a better api.
--
Michal Hocko
SUSE Labs

\
 
 \ /
  Last update: 2019-09-04 10:27    [W:0.131 / U:0.220 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site