lkml.org 
[lkml]   [2019]   [Sep]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [v3,1/2] dt-bindings: rtc: pcf85263/pcf85363: add some properties
On Tue, Sep 03, 2019 at 11:37:01AM +0200, Martin Fuzzey wrote:
> On 03/09/2019 08:18, Biwen Li wrote:
> > diff --git a/Documentation/devicetree/bindings/rtc/pcf85363.txt b/Documentation/devicetree/bindings/rtc/pcf85363.txt
> > index 94adc1cf93d9..588f688b30d1 100644
> > --- a/Documentation/devicetree/bindings/rtc/pcf85363.txt
> > +++ b/Documentation/devicetree/bindings/rtc/pcf85363.txt
> > @@ -8,10 +8,39 @@ Required properties:
> > Optional properties:
> > - interrupts: IRQ line for the RTC (not implemented).
> > +- interrupt-output-pin: The interrupt output pin must be
> > + "INTA" or "INTB", default value is "INTA"
> > +
>
>
> The hardware has 2 interrupt pins which can be mapped to various interrupt
> sources (alarm1, alarm2, periodic, ...)
>
> Currently the driver only supports alarm1.
>
> It is even possible to use both pins for the same interrupt (eg if INTA were
> wired to the SoC, INTB to a PMIC and both used for alarm...)
>
>
> So maybe it would be better to have
>
> alarm1-interrupt-output-pin: The interrupt output pin used for the alarm
> function. Must be "INTA", "INTB" or "BOTH"

That's a property per source. 2 properties possible sources (either a
mask or list) would be my preference.

Also, whatever you end up with needs a vendor prefix.

>
> Then, if and when other types of interrupts are supported by the driver new
> properties could be added for them.
>
>
>
> > +- quartz-load-femtofarads: The internal capacitor to select for the quartz:
> > + PCF85263_QUARTZCAP_7pF [0]
> > + PCF85263_QUARTZCAP_6pF [1]
> > + PCF85263_QUARTZCAP_12p5pF [2] DEFAULT
> > +
>
>
> The standard DT property "quartz-load-femtofarads" takes the real physical
> value in femto Farads ie values should be 7000, 6000, 12500 without defines.

I believe I said this on the last version.

>
>
> > +- nxp,quartz-drive-strength: Drive strength for the quartz:
> > + PCF85263_QUARTZDRIVE_100ko [0] DEFAULT
> > + PCF85263_QUARTZDRIVE_60ko [1]
> > + PCF85263_QUARTZDRIVE_500ko [2]
> > +
>
>
> Not sure about this.
>
> Wouldn't it be better to either use a real impedence value in ohms (like
> load property above, even though it is a vendor specific value) rather than
> a define, or defines for "Low, Medium, High"?
>
>
> Martin
>
>

\
 
 \ /
  Last update: 2019-09-03 19:37    [W:0.045 / U:4.804 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site