lkml.org 
[lkml]   [2019]   [Sep]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[Patch v4 5/8] media: dt-bindings: ov2659: add powerdown/reset-gpios optional property
Date
Add powerdown-gpios and reset-gpios to the list of optional properties
for the OV2659 camera sensor.

Signed-off-by: Benoit Parrot <bparrot@ti.com>
---
Documentation/devicetree/bindings/media/i2c/ov2659.txt | 9 +++++++++
1 file changed, 9 insertions(+)

diff --git a/Documentation/devicetree/bindings/media/i2c/ov2659.txt b/Documentation/devicetree/bindings/media/i2c/ov2659.txt
index cabc7d827dfb..92989a619f29 100644
--- a/Documentation/devicetree/bindings/media/i2c/ov2659.txt
+++ b/Documentation/devicetree/bindings/media/i2c/ov2659.txt
@@ -12,6 +12,12 @@ Required Properties:
- clock-names: should be "xvclk".
- link-frequencies: target pixel clock frequency.

+Optional Properties:
+- powerdown-gpios: reference to the GPIO connected to the pwdn pin, if any.
+ Active high with internal pull down resistor.
+- reset-gpios: reference to the GPIO connected to the resetb pin, if any.
+ Active low with internal pull up resistor.
+
For further reading on port node refer to
Documentation/devicetree/bindings/media/video-interfaces.txt.

@@ -27,6 +33,9 @@ Example:
clocks = <&clk_ov2659 0>;
clock-names = "xvclk";

+ powerdown-gpios = <&gpio6 14 GPIO_ACTIVE_HIGH>;
+ reset-gpios = <&gpio6 15 GPIO_ACTIVE_LOW>;
+
port {
ov2659_0: endpoint {
remote-endpoint = <&vpfe_ep>;
--
2.17.1
\
 
 \ /
  Last update: 2019-09-27 20:46    [W:0.088 / U:0.200 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site