lkml.org 
[lkml]   [2019]   [Sep]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v5 11/15] dmaengine: imx-sdma: fix ecspi1 rx dma not work on i.mx8mm
Date
Hi Robin,

> From: Robin Gong <yibin.gong at nxp.com>
>
> Because the number of ecspi1 rx event on i.mx8mm is 0, the condition
> check ignore such special case without dma channel enabled, which caused
> ecspi1 rx works failed. Actually, no need to check event_id0/event_id1
> and replace checking 'event_id1' with 'DMA_DEV_TO_DEV', so that configure
> event_id1 only in case DEV_TO_DEV.
>
> Signed-off-by: Robin Gong <yibin.gong at nxp.com>
> Acked-by: Vinod Koul <vkoul at kernel.org>

I have a custom board with i.MX8MM and SPI flash on ecspi1. I'm
currently testing with v5.3 and as SPI didn't work, I tried two
different things:

1. Removing 'dmas' and 'dma-names' from the ecspi1 node in imx8mm.dtsi,
to use PIO instead of DMA. This works as expected and the driver
boots with the following messages:

spi_imx 30820000.spi: dma setup error -19, use pio
m25p80 spi0.0: mx25v8035f (1024 Kbytes)
spi_imx 30820000.spi: probed

2. Applying your patchset and use DMA. In this case, the flash also
works fine, but there are some error messages printed while booting:

spi_master spi0: I/O Error in DMA RX
m25p80 spi0.0: SPI transfer failed: -110
spi_master spi0: failed to transfer one message from queue
m25p80 spi0.0: mx25v8035f (1024 Kbytes)
spi_imx 30820000.spi: probed

It would be great to get your patches merged and fix SPI + DMA, but for
i.MX8MM, we need to get rid of the error messages. Do you have an idea,
what's wrong?

Thanks,
Frieder
\
 
 \ /
  Last update: 2019-09-24 15:28    [W:0.266 / U:0.076 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site