lkml.org 
[lkml]   [2019]   [Sep]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3 6/8] ARM: dts: omap36xx: using OPP1G needs to control the abb_ldo
* H. Nikolaus Schaller <hns@goldelico.com> [190911 17:48]:
> See DM3730,DM275 data sheet (SPRS685B) footnote (6) in Table 4-19
> which says that ABB must be switched to FBB mode when using the
> OPP1G.
>
> The LOD definition abb_mpu_iva already exists so that we need
> to add plumbing for vbb-supply = <&abb_mpu_iva>
> and define two voltage vectors for each OPP so that the abb LDO
> is also updated by the ti-cpufreq driver.
>
> We also must switch the ti_cpufreq_soc_data to multi_regulator.
>
> Note: reading out the abb reglator voltage to verify that
> it does do transitions can be done by
>
> cat /sys/devices/platform/68000000.ocp/483072f0.regulator-abb-mpu/regulator/regulator.*/microvolts
>
> Likewise, read the twl4030 provided VDD voltage by
>
> cat /sys/devices/platform/68000000.ocp/48070000.i2c/i2c-0/0-0048/48070000.i2c:twl@48:regulator-vdd1/regulator/regulator.*/microvolts
>
> Note: to check if the ABB FBB is enabled/disabled, check
> registers
>
> PRM_LDO_ABB_CTRL 0x483072F4 bit 3:0 1=bypass 5=FBB
> PRM_LDO_ABB_SETUP 0x483072F0 0x00=bypass 0x11=FBB
>
> e.g.
>
> /dev/mem opened.
> Memory mapped at address 0xb6fe4000.
> Value at address 0x483072F4 (0xb6fe42f4): 0x3205
> /dev/mem opened.
> Memory mapped at address 0xb6f89000.
> Value at address 0x483072F4 (0xb6f892f4): 0x3201
>
> Note: omap34xx and am3517 have/need no comparable LDO
> or mechanism.

Acked-by: Tony Lindgren <tony@atomide.com>

\
 
 \ /
  Last update: 2019-09-16 18:27    [W:0.127 / U:0.476 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site