lkml.org 
[lkml]   [2019]   [Sep]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    From
    Subject[PATCH v3 0/8] OMAP3: convert opp-v1 to opp-v2 and read speed binned / 720MHz grade bits
    Date
    CHANGES V3:
    * make omap36xx control the abb-ldo and properly switch mode
    (suggested by Adam Ford <aford173@gmail.com>)
    * add a note about enabling the turbo-mode OPPs

    PATCH V2 2019-09-07 19:46:58:
    * fix ti-cpufreq to properly describe which compatible string is legacy
    * add some reviewed-by and acked-by Tony Lindgren <tony@atomide.com>
    * include am3517 patches by Adam Ford <aford173@gmail.com>
    * review opp-suspend; and add turbo-mode; opp properties
    * add a note how to disable an OPP in a board.dts file

    PATCH V1 2019-09-07 08:56:19:
    * fix typo in omap3-ldp.dts
    (reported by Tony Lindgren <tony@atomide.com>)
    * extend commit message to describe the bit patterns needed
    for opp-supported-hw
    * add error check to ioremap()
    (suggested by Christ van Willegen <cvwillegen@gmail.com>)
    * update Documentation/devicetree/bindings/arm/omap/omap.txt
    * change bulk update to use "ti,omap3430" and "ti,omap3630"
    * update OPP4 of omap3430 to 1275 mV since it was not a valid
    voltage for the twl4030 driver (reported by Tony Lindgren
    <tony@atomide.com>)

    RFC V2 2019-09-04 10:53:43:
    * merge separate patch to remove opp-v1 table from n950-n9 into
    the general omap3xxx.dtsi patch
    (suggested by Viresh Kumar <viresh.kumar@linaro.org>)
    * add legacy compatibility to ti,omap3430 and ti,omap3630 for
    the ti-cpufreq driver
    * make driver and omap3xxx.dtsi patches pass checkpatch
    * add bulk patch to explicitly define compatibility to ti,omap3430
    and ti,omap36xx in addition to ti,omap3 of all in-tree boards
    where it was missing

    RFC V1 2019-09-02 12:55:55:

    This patch set converts the omap3 opp tables to opp-v2 format
    and extends the ti-cpufreq to support omap3.

    It adds 720 MHz (omap34xx) and 1 GHz (omap36xx) OPPs but
    tells the ti-cpufreq driver to disable them if the speed
    binned / 720MHz grade eFuse bits indicate that the chip
    is not rated for that speed.

    It has been tested (for chip variant detection, not reliability
    of the high speed OPPs) on:

    * BeagleBoard C2 (omap3530 600MHz)
    * BeagleBoard XM B (dm3730 800MHz)
    * GTA04A4 (dm3730 800MHz)
    * GTA04A5 (dm3730 1GHz)


    Adam Ford (2):
    cpufreq: ti-cpufreq: Add support for AM3517
    ARM: dts: Add OPP-V2 table for AM3517

    H. Nikolaus Schaller (6):
    cpufreq: ti-cpufreq: add support for omap34xx and omap36xx
    ARM: dts: omap34xx & omap36xx: replace opp-v1 tables by opp-v2 for
    DTS: bindings: omap: update bindings documentation
    ARM: dts: omap3: bulk convert compatible to be explicitly ti,omap3430
    or ti,omap3630 or ti,am3517
    cpufreq: ti-cpufreq: omap36xx use "cpu0","vbb" if run in
    multi_regulator mode
    ARM: dts: omap36xx: using OPP1G needs to control the abb_ldo

    .../devicetree/bindings/arm/omap/omap.txt | 30 +++--
    .../bindings/cpufreq/ti-cpufreq.txt | 6 +-
    arch/arm/boot/dts/am3517.dtsi | 31 +++++
    arch/arm/boot/dts/am3517_mt_ventoux.dts | 2 +-
    .../boot/dts/logicpd-som-lv-35xx-devkit.dts | 2 +-
    .../boot/dts/logicpd-torpedo-35xx-devkit.dts | 2 +-
    arch/arm/boot/dts/omap3-beagle-xm.dts | 2 +-
    arch/arm/boot/dts/omap3-beagle.dts | 2 +-
    arch/arm/boot/dts/omap3-cm-t3530.dts | 2 +-
    arch/arm/boot/dts/omap3-cm-t3730.dts | 2 +-
    arch/arm/boot/dts/omap3-devkit8000-lcd43.dts | 2 +-
    arch/arm/boot/dts/omap3-devkit8000-lcd70.dts | 2 +-
    arch/arm/boot/dts/omap3-devkit8000.dts | 2 +-
    arch/arm/boot/dts/omap3-gta04.dtsi | 2 +-
    arch/arm/boot/dts/omap3-ha-lcd.dts | 2 +-
    arch/arm/boot/dts/omap3-ha.dts | 2 +-
    arch/arm/boot/dts/omap3-igep0020-rev-f.dts | 2 +-
    arch/arm/boot/dts/omap3-igep0020.dts | 2 +-
    arch/arm/boot/dts/omap3-igep0030-rev-g.dts | 2 +-
    arch/arm/boot/dts/omap3-igep0030.dts | 2 +-
    arch/arm/boot/dts/omap3-ldp.dts | 2 +-
    arch/arm/boot/dts/omap3-lilly-a83x.dtsi | 2 +-
    arch/arm/boot/dts/omap3-lilly-dbb056.dts | 2 +-
    arch/arm/boot/dts/omap3-n9.dts | 2 +-
    arch/arm/boot/dts/omap3-n950-n9.dtsi | 7 --
    arch/arm/boot/dts/omap3-n950.dts | 2 +-
    .../arm/boot/dts/omap3-overo-storm-alto35.dts | 2 +-
    .../boot/dts/omap3-overo-storm-chestnut43.dts | 2 +-
    .../boot/dts/omap3-overo-storm-gallop43.dts | 2 +-
    .../arm/boot/dts/omap3-overo-storm-palo35.dts | 2 +-
    .../arm/boot/dts/omap3-overo-storm-palo43.dts | 2 +-
    .../arm/boot/dts/omap3-overo-storm-summit.dts | 2 +-
    arch/arm/boot/dts/omap3-overo-storm-tobi.dts | 2 +-
    .../boot/dts/omap3-overo-storm-tobiduo.dts | 2 +-
    arch/arm/boot/dts/omap3-pandora-1ghz.dts | 2 +-
    arch/arm/boot/dts/omap3-sbc-t3530.dts | 2 +-
    arch/arm/boot/dts/omap3-sbc-t3730.dts | 2 +-
    arch/arm/boot/dts/omap3-sniper.dts | 2 +-
    arch/arm/boot/dts/omap3-thunder.dts | 2 +-
    arch/arm/boot/dts/omap3-zoom3.dts | 2 +-
    arch/arm/boot/dts/omap3430-sdp.dts | 2 +-
    arch/arm/boot/dts/omap34xx.dtsi | 66 ++++++++--
    arch/arm/boot/dts/omap36xx.dtsi | 65 ++++++++--
    drivers/cpufreq/cpufreq-dt-platdev.c | 2 +-
    drivers/cpufreq/ti-cpufreq.c | 119 +++++++++++++++++-
    45 files changed, 320 insertions(+), 80 deletions(-)

    --
    2.19.1

    \
     
     \ /
      Last update: 2019-09-11 19:48    [W:4.163 / U:0.016 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site