lkml.org 
[lkml]   [2019]   [Sep]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 3/3] iio: accel: adxl372: Perform a reset at start up
Date
We need to perform a reset a start up to make sure that the chip is in a
consistent state. This reset also disables all the interrupts which
should only be enabled together with the iio buffer. Not doing this, was
sometimes causing unwanted interrupts to trigger.

Signed-off-by: Stefan Popa <stefan.popa@analog.com>
---
Changes in v2:
- Instead of disabling the interrupts, now this patch performs
a software reset.

drivers/iio/accel/adxl372.c | 8 ++++++++
1 file changed, 8 insertions(+)

diff --git a/drivers/iio/accel/adxl372.c b/drivers/iio/accel/adxl372.c
index 33edca8..8a00528 100644
--- a/drivers/iio/accel/adxl372.c
+++ b/drivers/iio/accel/adxl372.c
@@ -575,6 +575,14 @@ static int adxl372_setup(struct adxl372_state *st)
return -ENODEV;
}

+ /*
+ * Perform a software reset to make sure the device is in a consistent
+ * state after start up.
+ */
+ ret = regmap_write(st->regmap, ADXL372_RESET, ADXL372_RESET_CODE);
+ if (ret < 0)
+ return ret;
+
ret = adxl372_set_op_mode(st, ADXL372_STANDBY);
if (ret < 0)
return ret;
--
2.7.4
\
 
 \ /
  Last update: 2019-09-10 16:45    [W:0.038 / U:0.108 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site