lkml.org 
[lkml]   [2019]   [Aug]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3] i2c: axxia: support slave mode
On Mon, Aug 19, 2019 at 09:07:07AM +0000, Adamski, Krzysztof (Nokia - PL/Wroclaw) wrote:
> This device contains both master and slave controllers which can be
> enabled simultaneously. Both controllers share the same SDA/SCL lines
> and interrupt source but has separate control and status registers.
> Controllers also works in loopback mode - slave device can communicate
> with its own master controller internally. The controller can handle up
> to two addresses, both of which may be 10 bit. Most of the logic
> (sending (N)ACK, handling repeated start or switching between
> write/read) is handled automatically which makes working with this
> controller quite easy.
>
> For simplicity, this patch adds basic support, limiting to only one
> slave address. Support for the 2nd device may be added in the future.
>
> Note that synchronize_irq() is used to ensure any running slave interrupt
> is finished to make sure slave i2c_client structure can be safely used
> by i2c_slave_event.
>
> Signed-off-by: Krzysztof Adamski <krzysztof.adamski@nokia.com>

Applied to for-next, thanks!

[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2019-08-29 21:09    [W:0.059 / U:37.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site