lkml.org 
[lkml]   [2019]   [Aug]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2 5/5] ARM: dts: ls1021a-tsn: Use the DSPI controller in poll mode
On Tue, 27 Aug 2019 at 21:13, Mark Brown <broonie@kernel.org> wrote:
>
> On Tue, Aug 27, 2019 at 09:06:14PM +0300, Vladimir Oltean wrote:
> > On Tue, 27 Aug 2019 at 21:05, Mark Brown <broonie@kernel.org> wrote:
> > > On Mon, Aug 26, 2019 at 04:10:51PM +0300, Vladimir Oltean wrote:
>
> > > > I noticed you skipped applying this patch, and I'm not sure that Shawn
> > > > will review it/take it.
> > > > Do you have a better suggestion how I can achieve putting the DSPI
> > > > driver in poll mode for this board? A Kconfig option maybe?
>
> > > DT changes go through the relevant platform trees, not the
> > > subsystem trees, so it's not something I'd expect to apply.
>
> > But at least is it something that you expect to see done through a
> > device tree change?
>
> Well, it's not ideal - if it performs better all the time the
> driver should probably just do it unconditionally. If there's
> some threashold where it tends to perform better then the driver
> should check for that but IIRC it sounds like the interrupt just
> isn't at all helpful here.

I can't seem to find any situation where it performs worse. Hence my
question on whether it's a better idea to condition this behavior on a
Kconfig option rather than a DT blob which may or may not be in sync.

\
 
 \ /
  Last update: 2019-08-27 20:17    [W:0.218 / U:0.160 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site