lkml.org 
[lkml]   [2019]   [Jul]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 0/3] Add IMX290 CMOS image sensor support
On Thu, Jul 04, 2019 at 12:32:27AM +0530, Manivannan Sadhasivam wrote:
> Hello,
>
> This patchset adds support for IMX290 CMOS image sensor from Sony.
> Sensor can be programmed through I2C and 4-wire interface but the
> current driver only supports I2C interface. Also, the sensor is
> capable of outputting frames in following 3 interfaces:
>
> * CMOS logic parallel SDR output
> * Low voltage LVDS serial DDR output
> * CSI-2 serial data output
>
> But the current driver only supports CSI-2 output available from 4 lanes.
> In the case of sensor resolution, driver only supports 1920x1080 and
> 1280x720 at mid data rate of 445.5 Mpbs.
>
> The driver has been validated using Framos IMX290 module interfaced to
> 96Boards Dragonboard410c.
>

Ping on the patchset!

Thanks,
Mani

> Thanks,
> Mani
>
> Manivannan Sadhasivam (3):
> dt-bindings: media: i2c: Add IMX290 CMOS sensor binding
> media: i2c: Add IMX290 CMOS image sensor driver
> MAINTAINERS: Add entry for IMX290 CMOS image sensor driver
>
> .../devicetree/bindings/media/i2c/imx290.txt | 51 ++
> MAINTAINERS | 8 +
> drivers/media/i2c/Kconfig | 11 +
> drivers/media/i2c/Makefile | 1 +
> drivers/media/i2c/imx290.c | 845 ++++++++++++++++++
> 5 files changed, 916 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/media/i2c/imx290.txt
> create mode 100644 drivers/media/i2c/imx290.c
>
> --
> 2.17.1
>

\
 
 \ /
  Last update: 2019-07-30 06:15    [W:0.080 / U:19.376 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site