lkml.org 
[lkml]   [2019]   [Jul]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] staging: erofs: fix LZ4 limited bounced page mis-reuse
From
Date


On 2019/7/3 14:51, Chao Yu wrote:
> Hi xiang,
>
> On 2019/7/3 14:06, Gao Xiang wrote:
>> Hi Chao,
>>
>> On 2019/7/3 10:09, Gao Xiang wrote:
>>>
>>>
>>> On 2019/7/3 9:50, Chao Yu wrote:
>>>> On 2019/7/1 2:58, Gao Xiang wrote:
>>>>> From: Gao Xiang <gaoxiang25@huawei.com>
>>>>>
>>>>> Like all lz77-based algrithms, lz4 has a dynamically populated
>>>>> ("sliding window") dictionary and the maximum lookback distance
>>>>> is 65535. Therefore the number of bounced pages could be limited
>>>>> by erofs based on this property.
>>>>>
>>>>> However, just now we observed some lz4 sequences in the extreme
>>>>> case cannot be decompressed correctly after this feature is enabled,
>>>>> the root causes after analysis are clear as follows:
>>>>> 1) max bounced pages should be 17 rather than 16 pages;
>>>>> 2) considering the following case, the broken implementation
>>>>> could reuse unsafely in advance (in other words, reuse it
>>>>> less than a safe distance),
>>>>> 0 1 2 ... 16 17 18 ... 33 34
>>>>> b p b b
>>>>> note that the bounce page that we are concerned was allocated
>>>>> at 0, and it reused at 18 since page 17 exists, but it mis-reused
>>>>> at 34 in advance again, which causes decompress failure.
>>>>>
>>>>> This patch resolves the issue by introducing a bitmap to mark
>>>>> whether the page in the same position of last round is a bounced
>>>>> page or not, and a micro stack data structure to store all
>>>>> available bounced pages.
>>>>>
>>>>> Fixes: 7fc45dbc938a ("staging: erofs: introduce generic decompression backend")
>>>>> Signed-off-by: Gao Xiang <gaoxiang25@huawei.com>
>>>>> ---
>>>>> drivers/staging/erofs/decompressor.c | 50 ++++++++++++++++------------
>>>>> 1 file changed, 28 insertions(+), 22 deletions(-)
>>>>>
>>>>> diff --git a/drivers/staging/erofs/decompressor.c b/drivers/staging/erofs/decompressor.c
>>>>> index 80f1f39719ba..1fb0abb98dff 100644
>>>>> --- a/drivers/staging/erofs/decompressor.c
>>>>> +++ b/drivers/staging/erofs/decompressor.c
>>>>> @@ -13,7 +13,7 @@
>>>>> #define LZ4_DISTANCE_MAX 65535 /* set to maximum value by default */
>>>>> #endif
>>>>>
>>>>> -#define LZ4_MAX_DISTANCE_PAGES DIV_ROUND_UP(LZ4_DISTANCE_MAX, PAGE_SIZE)
>>>>> +#define LZ4_MAX_DISTANCE_PAGES (DIV_ROUND_UP(LZ4_DISTANCE_MAX, PAGE_SIZE) + 1)
>>>>> #ifndef LZ4_DECOMPRESS_INPLACE_MARGIN
>>>>> #define LZ4_DECOMPRESS_INPLACE_MARGIN(srcsize) (((srcsize) >> 8) + 32)
>>>>> #endif
>>>>> @@ -35,19 +35,28 @@ static int lz4_prepare_destpages(struct z_erofs_decompress_req *rq,
>>>>> const unsigned int nr =
>>>>> PAGE_ALIGN(rq->pageofs_out + rq->outputsize) >> PAGE_SHIFT;
>>>>> struct page *availables[LZ4_MAX_DISTANCE_PAGES] = { NULL };
>>>>> - unsigned long unused[DIV_ROUND_UP(LZ4_MAX_DISTANCE_PAGES,
>>>>> - BITS_PER_LONG)] = { 0 };
>>>>> + unsigned long bounced[DIV_ROUND_UP(LZ4_MAX_DISTANCE_PAGES,
>>>>> + BITS_PER_LONG)] = { 0 };
>>>>> void *kaddr = NULL;
>>>>> - unsigned int i, j, k;
>>>>> + unsigned int i, j, top;
>>>>>
>>>>> - for (i = 0; i < nr; ++i) {
>>>>> + top = 0;
>>>>> + for (i = j = 0; i < nr; ++i, ++j) {
>>>>> struct page *const page = rq->out[i];
>>>>> + struct page *victim;
>>>>>
>>>>> - j = i & (LZ4_MAX_DISTANCE_PAGES - 1);
>>>>> - if (availables[j])
>>>>> - __set_bit(j, unused);
>>>>> + if (j >= LZ4_MAX_DISTANCE_PAGES)
>>>>> + j = 0;
>>>>> +
>>>>> + /* 'valid' bounced can only be tested after a complete round */
>>>>> + if (test_bit(j, bounced)) {
>>>>> + DBG_BUGON(i < LZ4_MAX_DISTANCE_PAGES);
>>>>> + DBG_BUGON(top >= LZ4_MAX_DISTANCE_PAGES);
>>>>> + availables[top++] = rq->out[i - LZ4_MAX_DISTANCE_PAGES];
>>>>
>>>> Maybe we can change 'i - LZ4_MAX_DISTANCE_PAGES' to 'j' directly for better
>>>> readability.
>>>
>>> OK, I think they are equivalent as well, will change for readability, retest and resend.
>>> Thanks for your suggestion :)
>>
>> I tested again and I observed that using j broke the logic and I think we cannot use j
>> to replace i - LZ4_MAX_DISTANCE_PAGES.
>>
>> Since bounced pages was marked according to the last round rather than the first round,
>> we cannot directly use the first round pages to push into the stack, e.g.
>
> Yes, I can understand that, so the bitmap only indicate page in previous round
> is a new bounced page or a referenced bounced page, using page at last round is
> safe.
>
> Anyway, thanks for the explanation below, and go ahead with current
> implementation. :)

Yes, thanks for the idea and taking time to review :)

Thanks,
Gao Xiang

>
> Thanks,
>
>>
>> 1)
>> 0 1 2 ... 16 17 18 ... 33 34
>> p b b
>>
>> bounce page could be allocated from rq->out[17], and we could reuse it from rq->out[34], which
>> is not equal to rq->out[0].
>>
>> 2)
>> 0 1 2 ... 16 17 18 19 ... 33 34 35 36
>> b p b b
>> allocated in rq->out[1] j = 1, reuse it in rq->out[19] j = 2, reuse it again in rq->out[36] j = 2,
>> which is not equal to rq->out[2].
>>
>> I think the original patch is ok, and it cannot be replaced to rq->out[j].
>>
>> Thanks,
>> Gao Xiang
>>
>>>
>>> Thanks,
>>> Gao Xiang
>>>
>>>>
>>>> Otherwise, it looks good to me.
>>>>
>>>> Reviewed-by: Chao Yu <yuchao0@huawei.com>
>>>>
>>>> Thanks,
>>>>
>>>>> + }
>>>>>
>>>>> if (page) {
>>>>> + __clear_bit(j, bounced);
>>>>> if (kaddr) {
>>>>> if (kaddr + PAGE_SIZE == page_address(page))
>>>>> kaddr += PAGE_SIZE;
>>>>> @@ -59,27 +68,24 @@ static int lz4_prepare_destpages(struct z_erofs_decompress_req *rq,
>>>>> continue;
>>>>> }
>>>>> kaddr = NULL;
>>>>> + __set_bit(j, bounced);
>>>>>
>>>>> - k = find_first_bit(unused, LZ4_MAX_DISTANCE_PAGES);
>>>>> - if (k < LZ4_MAX_DISTANCE_PAGES) {
>>>>> - j = k;
>>>>> - get_page(availables[j]);
>>>>> + if (top) {
>>>>> + victim = availables[--top];
>>>>> + get_page(victim);
>>>>> } else {
>>>>> - DBG_BUGON(availables[j]);
>>>>> -
>>>>> if (!list_empty(pagepool)) {
>>>>> - availables[j] = lru_to_page(pagepool);
>>>>> - list_del(&availables[j]->lru);
>>>>> - DBG_BUGON(page_ref_count(availables[j]) != 1);
>>>>> + victim = lru_to_page(pagepool);
>>>>> + list_del(&victim->lru);
>>>>> + DBG_BUGON(page_ref_count(victim) != 1);
>>>>> } else {
>>>>> - availables[j] = alloc_pages(GFP_KERNEL, 0);
>>>>> - if (!availables[j])
>>>>> + victim = alloc_pages(GFP_KERNEL, 0);
>>>>> + if (!victim)
>>>>> return -ENOMEM;
>>>>> }
>>>>> - availables[j]->mapping = Z_EROFS_MAPPING_STAGING;
>>>>> + victim->mapping = Z_EROFS_MAPPING_STAGING;
>>>>> }
>>>>> - rq->out[i] = availables[j];
>>>>> - __clear_bit(j, unused);
>>>>> + rq->out[i] = victim;
>>>>> }
>>>>> return kaddr ? 1 : 0;
>>>>> }
>>>>>
>> .
>>

\
 
 \ /
  Last update: 2019-07-03 09:11    [W:1.031 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site