lkml.org 
[lkml]   [2019]   [Jul]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v4 10/24] PM / devfreq: tegra30: Don't enable consecutive-down interrupt on startup
From
Date
16.07.2019 15:17, Chanwoo Choi пишет:
> Hi Dmitry,
>
> On 19. 7. 8. 오전 7:32, Dmitry Osipenko wrote:
>> The consecutive-down event tells that we should perform frequency
>> de-boosting, but boosting is in a reset state on start and hence the
>> event won't do anything useful for us and it will be just a dummy
>> interrupt request.
>>
>> Signed-off-by: Dmitry Osipenko <digetx@gmail.com>
>> ---
>> drivers/devfreq/tegra30-devfreq.c | 1 -
>> 1 file changed, 1 deletion(-)
>>
>> diff --git a/drivers/devfreq/tegra30-devfreq.c b/drivers/devfreq/tegra30-devfreq.c
>> index 32fe95458ee7..878c9396bb8c 100644
>> --- a/drivers/devfreq/tegra30-devfreq.c
>> +++ b/drivers/devfreq/tegra30-devfreq.c
>> @@ -558,7 +558,6 @@ static void tegra_actmon_configure_device(struct tegra_devfreq *tegra,
>> << ACTMON_DEV_CTRL_CONSECUTIVE_ABOVE_WMARK_NUM_SHIFT;
>> val |= ACTMON_DEV_CTRL_AVG_ABOVE_WMARK_EN;
>> val |= ACTMON_DEV_CTRL_AVG_BELOW_WMARK_EN;
>> - val |= ACTMON_DEV_CTRL_CONSECUTIVE_BELOW_WMARK_EN;
>> val |= ACTMON_DEV_CTRL_CONSECUTIVE_ABOVE_WMARK_EN;
>> val |= ACTMON_DEV_CTRL_ENB;
>>
>>
>
> Maybe, I think that better to review it by Thierry.
> I'm not sure it is right or not because it depend on h/w.
>

The CONSECUTIVE_LOWER interrupts are generated if
ACTMON_DEV_CTRL_CONSECUTIVE_BELOW_WMARK_EN is enabled and ISR enables
the BELOW_WMARK_EN bit once CONSECUTIVE_UPPER event is received. The
CONSECUTIVE events are used in for the frequency boosting logic and
there is no boosting on start, hence the CONSECUTIVE_LOWER event isn't
needed on start as well. Hope this helps.

\
 
 \ /
  Last update: 2019-07-16 17:18    [W:0.085 / U:3.072 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site