lkml.org 
[lkml]   [2019]   [Jun]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: KASAN: use-after-free Read in unregister_shrinker
From
Date
On 06.06.2019 18:18, Dmitry Vyukov wrote:
> On Thu, Jun 6, 2019 at 4:54 PM Kirill Tkhai <ktkhai@virtuozzo.com> wrote:
>>
>> On 06.06.2019 17:40, Dmitry Vyukov wrote:
>>> On Thu, Jun 6, 2019 at 3:43 PM Kirill Tkhai <ktkhai@virtuozzo.com> wrote:
>>>>
>>>> On 06.06.2019 16:13, J. Bruce Fields wrote:
>>>>> On Thu, Jun 06, 2019 at 10:47:43AM +0300, Kirill Tkhai wrote:
>>>>>> This may be connected with that shrinker unregistering is forgotten on error path.
>>>>>
>>>>> I was wondering about that too. Seems like it would be hard to hit
>>>>> reproduceably though: one of the later allocations would have to fail,
>>>>> then later you'd have to create another namespace and this time have a
>>>>> later module's init fail.
>>>>
>>>> Yes, it's had to bump into this in real life.
>>>>
>>>> AFAIU, syzbot triggers such the problem by using fault-injections
>>>> on allocation places should_failslab()->should_fail(). It's possible
>>>> to configure a specific slab, so the allocations will fail with
>>>> requested probability.
>>>
>>> No fault injection was involved in triggering of this bug.
>>> Fault injection is clearly visible in console log as "INJECTING
>>> FAILURE at this stack track" splats and also for bugs with repros it
>>> would be noted in the syzkaller repro as "fault_call": N. So somehow
>>> this bug was triggered as is.
>>>
>>> But overall syzkaller can do better then the old probabilistic
>>> injection. The probabilistic injection tend to both under-test what we
>>> want to test and also crash some system services. syzkaller uses the
>>> new "systematic fault injection" that allows to test specifically each
>>> failure site separately in each syscall separately.
>>
>> Oho! Interesting.
>
> If you are interested. You write N into /proc/thread-self/fail-nth
> (say, 5) then it will cause failure of the N-th (5-th) failure site in
> the next syscall in this task only. And by reading it back after the
> syscall you can figure out if the failure was indeed injected or not
> (or the syscall had less than 5 failure sites).
> Then, for each syscall in a test (or only for one syscall of
> interest), we start by writing "1" into /proc/thread-self/fail-nth; if
> the failure was injected, write "2" and restart the test; if the
> failure was injected, write "3" and restart the test; and so on, until
> the failure wasn't injected (tested all failure sites).
> This guarantees systematic testing of each error path with minimal
> number of runs. This has obvious extensions to "each pair of failure
> sites" (to test failures on error paths), but it's not supported atm.

And what you do in case of a tested syscall has pre-requisites? Say,
you test close(), which requires open() and some IO before. Are such
the dependencies statically declared in some configuration file? Or
you test any repeatable sequence of syscalls?

Kirill

\
 
 \ /
  Last update: 2019-06-06 17:26    [W:0.051 / U:0.324 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site