lkml.org 
[lkml]   [2019]   [Jun]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v8 08/13] drivers: memory: add DMC driver for Exynos5422
On Thu, 6 Jun 2019 at 12:38, Lukasz Luba <l.luba@partner.samsung.com> wrote:
> Hi Krzysztof,
> >> +/**
> >> + * exynos5_dmc_init_clks() - Initialize clocks needed for DMC operation.
> >> + * @dmc: DMC structure containing needed fields
> >> + *
> >> + * Get the needed clocks defined in DT device, enable and set the right parents.
> >> + * Read current frequency and initialize the initial rate for governor.
> >> + */
> >> +static int exynos5_dmc_init_clks(struct exynos5_dmc *dmc)
> >> +{
> >> + int ret;
> >> + unsigned long target_volt = 0;
> >> + unsigned long target_rate = 0;
> >> +
> >> + dmc->fout_spll = devm_clk_get(dmc->dev, "fout_spll");
> >> + if (IS_ERR(dmc->fout_spll))
> >> + return PTR_ERR(dmc->fout_spll);
> >> +
> >> + dmc->fout_bpll = devm_clk_get(dmc->dev, "fout_bpll");
> >> + if (IS_ERR(dmc->fout_bpll))
> >> + return PTR_ERR(dmc->fout_bpll);
> >> +
> >> + dmc->mout_mclk_cdrex = devm_clk_get(dmc->dev, "mout_mclk_cdrex");
> >> + if (IS_ERR(dmc->mout_mclk_cdrex))
> >> + return PTR_ERR(dmc->mout_mclk_cdrex);
> >
> > You are not enabling this clock. It is divider so it is fine for him
> > but what about its parents? How can you guarantee that parents are
> > enabled?
> It uses two parents in this configuration:
> 1. 'mout_bpll' which is set by the bootloader and is a default mode
> 2. 'mout_mx_mspll_ccore' which is used temporary as a 'bypass clock
> source' only for the time when BPLL is changing it's settings
>
> Do you suggest to put a call:
>
> to make sure the parent is up and running?
> OR just move the lines from the end of this function:
> clk_prepare_enable(dmc->fout_bpll);
> clk_prepare_enable(dmc->mout_bpll);
> and add:
> ret = clk_set_parent(dmc->mout_mclk_cdrex, dmc->mout_bpll);
> then call the clk_get_rate on 'mout_mclk_cdrex'
>

Ah, It's my mistake. I missed that later you enable its new parent. It's fine.

Best regards,
Krzysztof

\
 
 \ /
  Last update: 2019-06-06 13:46    [W:0.068 / U:2.116 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site