Messages in this thread | | | From | Kevin Hilman <> | Subject | Re: [PATCH v3 0/5] arch: riscv: add board and SoC DT file support | Date | Wed, 05 Jun 2019 10:36:58 -0700 |
| |
Hi Paul,
Paul Walmsley <paul.walmsley@sifive.com> writes:
> Add support for building flattened DT files from DT source files under > arch/riscv/boot/dts. Follow existing kernel precedent from other SoC > architectures. Start our board support by adding initial support for > the SiFive FU540 SoC and the first development board that uses it, the > SiFive HiFive Unleashed A00. > > This third version of the patch set adds I2C data for the chip, > incorporates all remaining changes that riscv-pk was making > automatically, and addresses a comment from Rob Herring > <robh@kernel.org>. > > Boot-tested on v5.2-rc1 on a HiFive Unleashed A00 board, using the > BBL and open-source FSBL, with modifications to pass in the DTB > file generated by these patches.
Tested this series on top of v5.2-rc3 on HiFive Unleashed board using OpenSBI + mainline u-boot (master branch as of today).
Tested-by: Kevin Hilman <khilman@baylibre.com>
> This patch series can be found, along with the PRCI patch set > and the DT macro prerequisite patch, at: > > https://github.com/sifive/riscv-linux/tree/dev/paulw/dts-v5.2-rc1
nit: I only see this series in that branch, not any of the prerequisite patches you mentioned, which made me assume I could this series alone on top of v5.2-rc3, which worked just fine.
Kevin
| |