lkml.org 
[lkml]   [2019]   [Jun]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] ARM: dts: am57xx: Disable voltage switching for SD card
* Faiz Abbas <faiz_abbas@ti.com> [190619 03:25]:
> If UHS speed modes are enabled, a compatible SD card switches down to
> 1.8V during enumeration. If after this a software reboot/crash takes
> place and on-chip ROM tries to enumerate the SD card, the difference in
> IO voltages (host @ 3.3V and card @ 1.8V) may end up damaging the card.
>
> The fix for this is to have support for power cycling the card in
> hardware (with a PORz/soft-reset line causing a power cycle of the
> card). Because the beaglebone X15 (rev A,B and C), am57xx-idks and
> am57xx-evms don't have this capability, disable voltage switching for
> these boards.
>
> The major effect of this is that the maximum supported speed
> mode is now high speed(50 MHz) down from SDR104(200 MHz).
>
> commit 88a748419b84 ("ARM: dts: am57xx-idk: Remove support for voltage
> switching for SD card") did this only for idk boards. Do it for all
> affected boards.

Thanks applying into fixes.

Regards,

Tony

\
 
 \ /
  Last update: 2019-06-27 13:40    [W:0.039 / U:0.672 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site