lkml.org 
[lkml]   [2019]   [Jun]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] arm64: dts: meson-g12a: add missing dwc2 phy-names
Date
The G12A USB2 OTG capable PHY uses a 8bit large UTMI bus, and the OTG
controller gets the PHY but width by probing the associated phy.

By default it will use 16bit wide settings if a phy is not specified,
in our case we specified the phy, but not the phy-names.

The dwc2 bindings specifies that if phys is present, phy-names shall be
"usb2-phy".

Adding phy-names = "usb2-phy" solves the OTG PHY bus configuration.

Fixes: 9baf7d6be730 ("arm64: dts: meson: g12a: Add G12A USB nodes")
Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
---
arch/arm64/boot/dts/amlogic/meson-g12a.dtsi | 1 +
1 file changed, 1 insertion(+)

diff --git a/arch/arm64/boot/dts/amlogic/meson-g12a.dtsi b/arch/arm64/boot/dts/amlogic/meson-g12a.dtsi
index f8d43e3dcf20..1785552d450c 100644
--- a/arch/arm64/boot/dts/amlogic/meson-g12a.dtsi
+++ b/arch/arm64/boot/dts/amlogic/meson-g12a.dtsi
@@ -2386,6 +2386,7 @@
clocks = <&clkc CLKID_USB1_DDR_BRIDGE>;
clock-names = "ddr";
phys = <&usb2_phy1>;
+ phy-names = "usb2-phy";
dr_mode = "peripheral";
g-rx-fifo-size = <192>;
g-np-tx-fifo-size = <128>;
--
2.21.0
\
 
 \ /
  Last update: 2019-06-25 14:37    [W:0.030 / U:9.788 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site