Messages in this thread | | | From | Jernej Škrabec <> | Subject | Re: [PATCH] drm/bridge: dw-hdmi: Use automatic CTS generation mode when using non-AHB audio | Date | Sat, 15 Jun 2019 11:17:10 +0200 |
| |
Dne sreda, 12. junij 2019 ob 10:51:47 CEST je Neil Armstrong napisal(a): > When using an I2S source using a different clock source (usually the I2S > audio HW uses dedicated PLLs, different from the HDMI PHY PLL), fixed > CTS values will cause some frequent audio drop-out and glitches as > reported on Amlogic, Allwinner and Rockchip SoCs setups. > > Setting the CTS in automatic mode will let the HDMI controller generate > automatically the CTS value to match the input audio clock. > > The DesignWare DW-HDMI User Guide explains: > For Automatic CTS generation > Write "0" on the bit field "CTS_manual", Register 0x3205: AUD_CTS3 > > The DesignWare DW-HDMI Databook explains : > If "CTS_manual" bit equals 0b this registers contains "audCTS[19:0]" > generated by the Cycle time counter according to specified timing. > > Cc: Jernej Skrabec <jernej.skrabec@siol.net> > Cc: Maxime Ripard <maxime.ripard@bootlin.com> > Cc: Jonas Karlman <jonas@kwiboo.se> > Cc: Heiko Stuebner <heiko@sntech.de> > Cc: Jerome Brunet <jbrunet@baylibre.com> > Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
Tested-by: Jernej Skrabec <jernej.skrabec@siol.net> Reviewed-by: Jernej Skrabec <jernej.skrabec@siol.net>
Best regards, Jernej
| |