lkml.org 
[lkml]   [2019]   [Jun]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[RESEND PATCH v2 3/3] regulator: lp87565: Add 4-phase lp87561 regulator support
Date
The LP8756x family has a single output 4-phase regulator
configuration. Add support for the same. The control
lies in the master buck which is buck0 for 4-phase
configuration. Enable/disable/voltage set happen via
buck0 registers.

Data Sheet: https://www.ti.com/lit/ds/symlink/lp87561-q1.pdf

Signed-off-by: Keerthy <j-keerthy@ti.com>
Acked-by: Mark Brown <broonie@kernel.org>
---

patches 1/3 2/3 are already applied to linux-next.

Changes in v2:

* Changed if/else block to switch statement.

drivers/regulator/lp87565-regulator.c | 17 ++++++++++++++++-
1 file changed, 16 insertions(+), 1 deletion(-)

diff --git a/drivers/regulator/lp87565-regulator.c b/drivers/regulator/lp87565-regulator.c
index 81eb4b890c0c..af00d1ffcf33 100644
--- a/drivers/regulator/lp87565-regulator.c
+++ b/drivers/regulator/lp87565-regulator.c
@@ -153,6 +153,12 @@ static const struct lp87565_regulator regulators[] = {
LP87565_REG_BUCK2_CTRL_1,
LP87565_BUCK_CTRL_1_EN, 3230,
buck0_1_2_3_ranges, LP87565_REG_BUCK2_CTRL_2),
+ LP87565_REGULATOR("BUCK3210", LP87565_BUCK_3210, "buck3210",
+ lp87565_buck_ops, 256, LP87565_REG_BUCK0_VOUT,
+ LP87565_BUCK_VSET, LP87565_REG_BUCK0_CTRL_1,
+ LP87565_BUCK_CTRL_1_EN |
+ LP87565_BUCK_CTRL_1_FPWM_MP_0_2, 3230,
+ buck0_1_2_3_ranges, LP87565_REG_BUCK0_CTRL_2),
};

static int lp87565_regulator_probe(struct platform_device *pdev)
@@ -169,9 +175,18 @@ static int lp87565_regulator_probe(struct platform_device *pdev)
config.driver_data = lp87565;
config.regmap = lp87565->regmap;

- if (lp87565->dev_type == LP87565_DEVICE_TYPE_LP87565_Q1) {
+ switch (lp87565->dev_type) {
+ case LP87565_DEVICE_TYPE_LP87565_Q1:
min_idx = LP87565_BUCK_10;
max_idx = LP87565_BUCK_23;
+ break;
+ case LP87565_DEVICE_TYPE_LP87561_Q1:
+ min_idx = LP87565_BUCK_3210;
+ max_idx = LP87565_BUCK_3210;
+ default:
+ dev_err(lp87565->dev, "Invalid lp config %d\n",
+ lp87565->dev_type);
+ return -EINVAL;
}

for (i = min_idx; i <= max_idx; i++) {
--
2.17.1
\
 
 \ /
  Last update: 2019-06-12 16:45    [W:0.060 / U:8.256 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site