lkml.org 
[lkml]   [2019]   [Jun]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/3] mmc: sdhci: sdhci-pci-o2micro: Check if controller supports 8-bit width
Date
The O2 controller supports 8-bit EMMC access. mmc_select_bus_width()
will be used to determine if the MMC supports 8-bit or 4-bit access.

Signed-off-by: Raul E Rangel <rrangel@chromium.org>
---
I tested this on an AMD chromebook.

$ cat /sys/kernel/debug/mmc1/ios
clock: 200000000 Hz
actual clock: 200000000 Hz
vdd: 21 (3.3 ~ 3.4 V)
bus mode: 2 (push-pull)
chip select: 0 (don't care)
power mode: 2 (on)
bus width: 3 (8 bits)
timing spec: 9 (mmc HS200)
signal voltage: 1 (1.80 V)
driver type: 0 (driver type B)

Before this patch only 4 bit was negotiated.

drivers/mmc/host/sdhci-pci-o2micro.c | 7 ++++++-
1 file changed, 6 insertions(+), 1 deletion(-)

diff --git a/drivers/mmc/host/sdhci-pci-o2micro.c b/drivers/mmc/host/sdhci-pci-o2micro.c
index dd21315922c87..07bb91cbdf1f8 100644
--- a/drivers/mmc/host/sdhci-pci-o2micro.c
+++ b/drivers/mmc/host/sdhci-pci-o2micro.c
@@ -395,11 +395,16 @@ int sdhci_pci_o2_probe_slot(struct sdhci_pci_slot *slot)
{
struct sdhci_pci_chip *chip;
struct sdhci_host *host;
- u32 reg;
+ u32 reg, caps;
int ret;

chip = slot->chip;
host = slot->host;
+
+ caps = sdhci_readl(host, SDHCI_CAPABILITIES);
+ if (caps & SDHCI_CAN_DO_8BIT)
+ host->mmc->caps |= MMC_CAP_8_BIT_DATA;
+
switch (chip->pdev->device) {
case PCI_DEVICE_ID_O2_SDS0:
case PCI_DEVICE_ID_O2_SEABIRD0:
--
2.22.0.rc2.383.gf4fbbf30c2-goog
\
 
 \ /
  Last update: 2019-06-10 20:56    [W:0.130 / U:0.680 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site