lkml.org 
[lkml]   [2019]   [Jun]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v1 2/4] dt-bindings: net: bluetooth: add clock property to UART-based device
Date
From: Sean Wang <sean.wang@mediatek.com>

Some board requires explicitily control external osscilator via GPIO.
So, add a clock property for an external oscillator for the device.

Signed-off-by: Sean Wang <sean.wang@mediatek.com>
---
Documentation/devicetree/bindings/net/mediatek-bluetooth.txt | 4 ++++
1 file changed, 4 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/mediatek-bluetooth.txt b/Documentation/devicetree/bindings/net/mediatek-bluetooth.txt
index 14f23b354a6d..112011c51d5e 100644
--- a/Documentation/devicetree/bindings/net/mediatek-bluetooth.txt
+++ b/Documentation/devicetree/bindings/net/mediatek-bluetooth.txt
@@ -73,6 +73,10 @@ Optional properties:
- reset-gpios: GPIO used to reset the device whose initial state keeps low,
if the GPIO is missing, then board-level design should be
guaranteed.
+- clocks: Should be the clock specifiers corresponding to the entry in
+ clock-names property. If the clock is missing, then board-level
+ design should be guaranteed.
+- clock-names: Should contain "osc" entry for the external oscillator.
- current-speed: Current baud rate of the device whose defaults to 921600

Example:
--
2.17.1
\
 
 \ /
  Last update: 2019-06-02 03:05    [W:0.044 / U:0.592 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site