Messages in this thread | | | Date | Fri, 10 May 2019 11:05:26 +0800 | From | Shawn Guo <> | Subject | Re: [PATCH] arm64: defconfig: Enable FSL_EDMA driver |
| |
On Mon, Apr 22, 2019 at 01:30:56PM -0500, Li Yang wrote: > Enables the FSL EDMA driver by default. This also works around an issue > that imx-i2c driver keeps deferring the probe because of the DMA is not > ready. And currently the DMA engine framework can not correctly tell > if the DMA channels will truly become available later (it will never be > available if the DMA driver is not enabled). > > This will cause indefinite messages like below: > [ 3.335829] imx-i2c 2180000.i2c: can't get pinctrl, bus recovery not supported > [ 3.344455] ina2xx 0-0040: power monitor ina220 (Rshunt = 1000 uOhm) > [ 3.350917] lm90 0-004c: 0-004c supply vcc not found, using dummy regulator > [ 3.362089] imx-i2c 2180000.i2c: can't get pinctrl, bus recovery not supported > [ 3.370741] ina2xx 0-0040: power monitor ina220 (Rshunt = 1000 uOhm) > [ 3.377205] lm90 0-004c: 0-004c supply vcc not found, using dummy regulator > [ 3.388455] imx-i2c 2180000.i2c: can't get pinctrl, bus recovery not supported > ..... > > Signed-off-by: Li Yang <leoyang.li@nxp.com>
Applied, thanks.
| |