lkml.org 
[lkml]   [2019]   [May]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v7 1/3] media: cec: expose HDMI connector to CEC dev mapping
From
Date
On 5/28/19 9:53 AM, Dariusz Marcinkiewicz wrote:
> On Fri, May 24, 2019 at 11:21 AM Hans Verkuil <hverkuil@xs4all.nl> wrote:
>>
>> Hi Dariusz,
>>
>> I did some more testing with the Khadas VIM2 and found another problem,
>> something that will, unfortunately, require some redesign.
>>
> ...
>>
>> The other problem is in the CEC driver: it creates the CEC device as
>> soon as the HDMI device is found (cec_notifier_parse_hdmi_phandle).
>>
>> But that doesn't mean that the HDMI device also had registered itself
>> as a CEC notifier.
>>
>> Until now that never mattered: as long as the HDMI device was found
>> the CEC adapter would function fine, it would just have no physical
>> address until so notified by the HDMI device once it registered its
>> CEC notifier.
>>
>> But if we want to have valid connector info during the lifetime of
>> the CEC adapter, then this no longer works.
>>
>> I'm not entirely sure how to handle this.
>>
>> Another issue here is that when the HDMI driver removes the notifier,
>> then it should also zero the connector info. Remember that both the
>> HDMI and the CEC drivers can be loaded and unloaded independently from
>> one another.
>>
> Given all of the above, what do you think about coming back to the v1
> of the patch, where a connector info could be set on an adapter at any
> time and an event was used to notify userland when that happened? That
> approach seems to cover all the scenarios mentioned above.

That's just hiding the real problems :-)

I hope to spend some time on CEC tomorrow and I'll get back to you then.

Regards,

Hans

\
 
 \ /
  Last update: 2019-05-28 10:06    [W:1.017 / U:0.068 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site