lkml.org 
[lkml]   [2019]   [May]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 1/3] firmware: qcom_scm: Use proper types for dma mappings
From
Date
Hi Ian,

On 20/05/2019 10:41, Ian Jackson wrote:
> Stephen Boyd writes ("[PATCH 1/3] firmware: qcom_scm: Use proper types for dma mappings"):
>> We need to use the proper types and convert between physical addresses
>> and dma addresses here to avoid mismatch warnings. This is especially
>> important on systems with a different size for dma addresses and
>> physical addresses. Otherwise, we get the following warning:
>
> Thanks. Do you expect this to be a backport candidate and if so how
> far back do you think it will go ? To be honest, I am not really
> convinced that backporting this would be a service to users. The
> situation I have, where I changed the compiler but kept the old kernel
> code and old configuration, is going to be fairly rare.

I will leave the maintainers answering to that.

>
> I think I should probably therefore disable this driver in the config
> on stable branches of Linux, at least.

If we decide to disable the driver, then we would need to add in our .config,
then we would need to disable completely the support for Qualcomm (i.e
CONFIG_ARCH_QCOM=n) on Arm32.

This should not be an issue in osstest as we don't test any qualcomm board so far.

Cheers,

--
Julien Grall

\
 
 \ /
  Last update: 2019-05-20 15:21    [W:0.280 / U:0.280 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site