lkml.org 
[lkml]   [2019]   [May]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/2] mtd: nand: raw: brcmnand: fallback to detected ecc-strength, ecc-step-size
Date
This change supports nand-ecc-step-size and nand-ecc-strenght fields in
brcmnand dt node to be optional.
see: Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt

If both nand-ecc-strength and nand-ecc-step-size are not specified in
device tree node for NAND, nand_base driver does detect onfi ext ecc
info from ONFI extended parameter page for parts using ONFI >= 2.1. In
case of non-onfi NAND there could be a nand_id table entry with the ecc
info. If there is a valid device tree entry for nand-ecc-strength and
nand-ecc-step-size fields it still shall override the detected values.

Signed-off-by: Kamal Dasu <kdasu.kdev@gmail.com>
---
drivers/mtd/nand/raw/brcmnand/brcmnand.c | 10 ++++++++++
1 file changed, 10 insertions(+)

diff --git a/drivers/mtd/nand/raw/brcmnand/brcmnand.c b/drivers/mtd/nand/raw/brcmnand/brcmnand.c
index ce0b8ff..e967b30 100644
--- a/drivers/mtd/nand/raw/brcmnand/brcmnand.c
+++ b/drivers/mtd/nand/raw/brcmnand/brcmnand.c
@@ -2144,6 +2144,16 @@ static int brcmnand_setup_dev(struct brcmnand_host *host)
return -EINVAL;
}

+ if (!(chip->ecc.size > 0 && chip->ecc.strength > 0) &&
+ (chip->base.eccreq.strength > 0 &&
+ chip->base.eccreq.step_size > 0)) {
+ /* use detected ecc parameters */
+ chip->ecc.size = chip->base.eccreq.step_size;
+ chip->ecc.strength = chip->base.eccreq.strength;
+ pr_info("Using detected nand-ecc-step-size %d, nand-ecc-strength %d\n",
+ chip->ecc.size, chip->ecc.strength);
+ }
+
switch (chip->ecc.size) {
case 512:
if (chip->ecc.algo == NAND_ECC_HAMMING)
--
1.9.0.138.g2de3478
\
 
 \ /
  Last update: 2019-05-17 20:34    [W:0.063 / U:7.716 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site