lkml.org 
[lkml]   [2019]   [May]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/2] dt-bindings: pinctrl: meson: add output support in pinconf
Date
add support for the pinconf DT property output-enable, output-disable,
output-low and output-high in the meson pinctrl driver.

Signed-off-by: Jerome Brunet <jbrunet@baylibre.com>
---
.../devicetree/bindings/pinctrl/meson,pinctrl.txt | 12 +++++++++---
1 file changed, 9 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt
index a7618605bf1e..10dc4f7176ca 100644
--- a/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt
+++ b/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt
@@ -47,9 +47,15 @@ Required properties for pinmux nodes are:
Required properties for configuration nodes:
- pins: a list of pin names

-Configuration nodes support the generic properties "bias-disable",
-"bias-pull-up" and "bias-pull-down", described in file
-pinctrl-bindings.txt
+Configuration nodes support the following generic properties, as
+described in file pinctrl-bindings.txt:
+ - "bias-disable"
+ - "bias-pull-up"
+ - "bias-pull-down"
+ - "output-enable"
+ - "output-disable"
+ - "output-low"
+ - "output-high"

Optional properties :
- drive-strength-microamp: Drive strength for the specified pins in uA.
--
2.20.1
\
 
 \ /
  Last update: 2019-05-16 17:14    [W:1.257 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site