lkml.org 
[lkml]   [2019]   [Apr]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 07/12] arm64: dts: allwinner: orange-pi-3: Enable ethernet
On Sat, Apr 06, 2019 at 01:45:09AM +0200, megous@megous.com wrote:
> From: Ondrej Jirman <megous@megous.com>
>
> Orange Pi 3 has two regulators that power the Realtek RTL8211E.
> According to the phy datasheet, both regulators need to be enabled
> at the same time, but we can only specify a single phy-supply in
> the DT.
>
> This can be achieved by making one regulator depedning on the
> other via vin-supply. While it's not a technically correct
> description of the hardware, it achieves the purpose.
>
> All values of RX/TX delay were tested exhaustively and a middle
> one of the working values was chosen.
>
> Signed-off-by: Ondrej Jirman <megous@megous.com>
> ---
> .../dts/allwinner/sun50i-h6-orangepi-3.dts | 44 +++++++++++++++++++
> 1 file changed, 44 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts
> index 644946749088..5270142527f5 100644
> --- a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts
> +++ b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts
> @@ -15,6 +15,7 @@
>
> aliases {
> serial0 = &uart0;
> + ethernet0 = &emac;
> };
>
> chosen {
> @@ -64,6 +65,27 @@
> regulator-max-microvolt = <5000000>;
> regulator-always-on;
> };
> +
> + /*
> + * The board uses 2.5V RGMII signalling. Power sequence
> + * to enable the phy is to enable GMAC-2V5 and GMAC-3V3 (aldo2)
> + * power rails at the same time and to wait 100ms.
> + */
> + reg_gmac_2v5: gmac-2v5 {
> + compatible = "regulator-fixed";
> + regulator-name = "gmac-2v5";
> + regulator-min-microvolt = <2500000>;
> + regulator-max-microvolt = <2500000>;
> + startup-delay-us = <100000>;
> + enable-active-high;
> + gpio = <&pio 3 6 GPIO_ACTIVE_HIGH>; /* PD6 */

Is enable-active-high still needed? It's redundant with the
GPIO_ACTIVE_HIGH flag.

The indentation is wrong here as well.

Maxime

--
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2019-04-08 09:41    [W:0.120 / U:0.332 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site