lkml.org 
[lkml]   [2019]   [Apr]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH 1/2] dt-bindings: rtc: add battery-low-hw-alarm property
Date
Hi,


> On 03/04/2019 15:06:17+0000, Flavio Suligoi wrote:
> > Hi Alexandre,
> >
> > > Hi,
> > >
> > > On 03/04/2019 16:52:44+0200, Flavio Suligoi wrote:
> > > > Some RTC devices have a battery-low automatic detection circuit.
> > > > The battery-low event is usually reported with:
> > > >
> > > > - a bit change in a RTC status register
> > > > - a hw signaling (generally using an interrupt generation), changing
> > > > the hw level of a specific pin;
> > > >
> > > > The new property "battery-low-hw-alarm" enable the RTC to generate
> the
> > > > hw signaling in case of battery-low event.
> > > >
> > > > Signed-off-by: Flavio Suligoi <f.suligoi@asem.it>
> > > > ---
> > > > Documentation/devicetree/bindings/rtc/rtc.txt | 3 +++
> > > > 1 file changed, 3 insertions(+)
> > > >
> > > > diff --git a/Documentation/devicetree/bindings/rtc/rtc.txt
> > > b/Documentation/devicetree/bindings/rtc/rtc.txt
> > > > index a97fc6a..f93a44d 100644
> > > > --- a/Documentation/devicetree/bindings/rtc/rtc.txt
> > > > +++ b/Documentation/devicetree/bindings/rtc/rtc.txt
> > > > @@ -31,6 +31,9 @@ below.
> > > > expressed in femto Farad (fF).
> > > > The default value shall be listed (if
> > > optional),
> > > > and likewise all valid values.
> > > > +- battery-low-hw-alarm : Enable the "battery-low" output pin.
> This
> > > function
> > >
> > > I would name that voltage-low-alarm as not all the secondary voltages
> > > are batteries.
> >
> > You have right. So we can also name the property a: "voltage-low-hw-
> alarm".
> > I prefer to have the word "hw" in the property name, since the "sw"
> voltage
> > low alarm is already present is some RTC drivers.
> > In this way, with the word "hw", is more clear that we are speaking
> about
> > an hw pin signaling.
> >
>
> Well, the device tree always describes the hardware so there is no point
> in specifying hw.

Right, so I rename the property in "voltage-low-alarm"

>
>
> --
> Alexandre Belloni, Bootlin
> Embedded Linux and Kernel engineering
> https://bootlin.com

Flavio Suligoi

\
 
 \ /
  Last update: 2019-04-03 17:32    [W:0.060 / U:0.068 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site