lkml.org 
[lkml]   [2019]   [Apr]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2] mmc: core: Verify SD bus width
On Thu, Apr 18, 2019 at 06:20:26AM +0000, Avri Altman wrote:
> >
> > The SD Physical Layer Spec says the following: Since the SD Memory Card
> > shall support at least the two bus modes 1-bit or 4-bit width, then any SD
> > Card shall set at least bits 0 and 2 (SD_BUS_WIDTH="0101").
> >
> > This change verifies the card has specified a bus width.
> >
> > AMD SDHC Device 7806 can get into a bad state after a card disconnect
> > where anything transferred via the DATA lines will always result in a
> > zero filled buffer. Currently the driver will continue without error if
> > the HC is in this condition. A block device will be created, but reading
> > from it will result in a zero buffer. This makes it seem like the SD
> > device has been erased, when in actuality the data is never getting
> > copied from the DATA lines to the data buffer.
> >
> > SCR is the first command in the SD initialization sequence that uses the
> > DATA lines. By checking that the response was invalid, we can abort
> > mounting the card.
> >
> > Acked-by: Avri Altman <avri.altman@wdc.com>
> >
> > Signed-off-by: Raul E Rangel <rrangel@chromium.org>
> Reviewed-by: Avri Altman <avri.altman@wdc.com>
>
> Thanks,
> Avri
Thanks for the review. Should I rebase this on master so it applies
cleanly without the MMC trace patches?

Raul

\
 
 \ /
  Last update: 2019-04-24 17:58    [W:0.111 / U:0.448 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site