lkml.org 
[lkml]   [2019]   [Apr]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 4/5] OPP: Update the bandwidth on OPP frequency changes
Date
If the OPP bandwidth values are populated, we want to switch also the
interconnect bandwidth in addition to frequency and voltage.

Signed-off-by: Georgi Djakov <georgi.djakov@linaro.org>
---
drivers/opp/core.c | 9 ++++++++-
1 file changed, 8 insertions(+), 1 deletion(-)

diff --git a/drivers/opp/core.c b/drivers/opp/core.c
index 97ee39ecdebd..91d1c2abfb3e 100644
--- a/drivers/opp/core.c
+++ b/drivers/opp/core.c
@@ -707,7 +707,7 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq)
unsigned long freq, old_freq;
struct dev_pm_opp *old_opp, *opp;
struct clk *clk;
- int ret;
+ int ret, i;

if (unlikely(!target_freq)) {
dev_err(dev, "%s: Invalid target frequency %lu\n", __func__,
@@ -780,6 +780,13 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq)
ret = _generic_set_opp_clk_only(dev, clk, freq);
}

+ if (!ret && !IS_ERR_OR_NULL(opp_table->paths)) {
+ for (i = 0; i < opp_table->path_count; i++) {
+ icc_set_bw(opp_table->paths[i], opp->bandwidth[i].avg,
+ opp->bandwidth[i].peak);
+ }
+ }
+
/* Scaling down? Configure required OPPs after frequency */
if (!ret && freq < old_freq) {
ret = _set_required_opps(dev, opp_table, opp);
\
 
 \ /
  Last update: 2019-04-23 15:29    [W:0.232 / U:0.160 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site