lkml.org 
[lkml]   [2019]   [Apr]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH V3 1/2] ASoC: fsl_asrc: replace the process_option table with function
Date
Hi

>
> On Thu, Apr 18, 2019 at 08:50:48AM +0000, S.j. Wang wrote:
> > > And this is according to IMX6DQRM:
> > > Limited support for the case when output sampling rates is
> > > between 8kHz and 30kHz. The limitation is the supported ratio
> > > (Fsin/Fsout) range as between 1/24 to 8
> > >
> > > This should cover your 8.125 condition already, even if having an
> > > outrate range between [8KHz, 30KHz] check, since an outrate above
> > > 30KHz will not have an inrate bigger than 8.125 times of it, given
> > > the maximum input rate is 192KHz.
> > >
> > > So I think that we can just drop that 8.125 condition from your
> > > change and there's no need to error out any more.
> > >
> > No, if outrate=8kHz, inrate > 88.2kHz, these cases are not supported.
> > This is not covered by
> >
> > if ((outrate > 8000 && outrate < 30000) &&
> > (outrate/inrate > 24 || inrate/outrate > 8)) {
>
> Good catch. The range should be [8KHz, 30KHz] vs. (8KHz, 32KHz) in the
> code. Then I think the fix should be at both lines:
>
> - if ((outrate > 8000 && outrate < 30000) &&
> - (outrate/inrate > 24 || inrate/outrate > 8)) {
> + if ((outrate >= 8000 && outrate =< 30000) &&
> + (outrate > 24 * inrate || inrate > 8 * outrate)) {
>
> Overall, I think we should fix this instead of adding an extra one, since it is
> very likely saying the same thing.

Actually if outrate < 8kHz, there will be issue too.

Best regards
Wang shengjiu

\
 
 \ /
  Last update: 2019-04-18 11:37    [W:0.035 / U:2.620 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site