[lkml]   [2019]   [Apr]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH 5.0 089/117] ARM: dts: rockchip: Fix SD card detection on rk3288-tinker
From: David Summers <>

commit 8dbc4d5ddb59f49cb3e85bccf42a4720b27a6576 upstream.

The Problem:

On ASUS Tinker Board S, when booting from the eMMC, and there is card
in the sd slot, there are constant errors.

Also when warm reboot, uboot can not access the sd slot


Identified by Robin Murphy @ ARM. The Card Detect on rk3288
devices is pulled up by vccio-sd; so when the regulator powers this
off, card detect gives spurious errors. A second problem, is during
power down, vccio-sd apprears to be powered down. This causes a
problem when warm rebooting from the sd card. This was identified by
Jonas Karlman.


A common fault on these rk3288 board, which impliment the reference

When this arose before:

And Ulf and Jaehoon clearly said this was a broken card detect design,
which should be solved via polling


Hence broken-cd is set as a property. This cures the errors. The
powering down of vccio-sd during reboot is cured by adding

This solutions has been fairly widely reviewed and tested.

Fixes: e58c5e739d6f ("ARM: dts: rockchip: move shared tinker-board nodes to a common dtsi")
[Heiko: slightly inaccurate fixes but tinker is a sbc (aka like a Pi) where
we can hopefully expect people not to rely on overly old stable kernels]
Signed-off-by: David Summers <>
Reviewed-by: Jonas Karlman <>
Tested-by: Jonas Karlman <>
Reviewed-by: Robin Murphy <>
Signed-off-by: Heiko Stuebner <>
Signed-off-by: Greg Kroah-Hartman <>

arch/arm/boot/dts/rk3288-tinker.dtsi | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)

--- a/arch/arm/boot/dts/rk3288-tinker.dtsi
+++ b/arch/arm/boot/dts/rk3288-tinker.dtsi
@@ -254,6 +254,7 @@

vccio_sd: LDO_REG5 {
+ regulator-boot-on;
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <3300000>;
regulator-name = "vccio_sd";
@@ -430,7 +431,7 @@
bus-width = <4>;
- card-detect-delay = <200>;
+ broken-cd;
disable-wp; /* wp not hooked up */
pinctrl-names = "default";
pinctrl-0 = <&sdmmc_clk &sdmmc_cmd &sdmmc_cd &sdmmc_bus4>;

 \ /
  Last update: 2019-04-15 21:17    [W:0.395 / U:5.180 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site