lkml.org 
[lkml]   [2019]   [Apr]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 4/9] ARM: at91: Implement clocksource selection
Date
Allow selecting and unselecting the PIT clocksource driver so it doesn't
have to be compiled when unused.

Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
---
arch/arm/mach-at91/Kconfig | 23 +++++++++++++++++++++++
1 file changed, 23 insertions(+)

diff --git a/arch/arm/mach-at91/Kconfig b/arch/arm/mach-at91/Kconfig
index 903f23c309df..da1d97a06c53 100644
--- a/arch/arm/mach-at91/Kconfig
+++ b/arch/arm/mach-at91/Kconfig
@@ -107,6 +107,29 @@ config SOC_AT91SAM9
AT91SAM9X35
AT91SAM9XE

+comment "Clocksource driver selection"
+
+config ATMEL_CLOCKSOURCE_PIT
+ bool "Periodic Interval Timer (PIT) support"
+ depends on SOC_AT91SAM9 || SOC_SAMA5
+ default SOC_AT91SAM9 || SOC_SAMA5
+ select ATMEL_PIT
+ help
+ Select this to get a clocksource based on the Atmel Periodic Interval
+ Timer. It has a relatively low resolution and the TC Block clocksource
+ should be preferred.
+
+config ATMEL_CLOCKSOURCE_TCB
+ bool "Timer Counter Blocks (TCB) support"
+ default SOC_AT91RM9200 || SOC_AT91SAM9 || SOC_SAMA5
+ select ATMEL_TCB_CLKSRC
+ help
+ Select this to get a high precision clocksource based on a
+ TC block with a 5+ MHz base clock rate.
+ On platforms with 16-bit counters, two timer channels are combined
+ to make a single 32-bit timer.
+ It can also be used as a clock event device supporting oneshot mode.
+
config HAVE_AT91_UTMI
bool

--
2.20.1
\
 
 \ /
  Last update: 2019-04-15 17:10    [W:0.044 / U:0.228 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site