lkml.org 
[lkml]   [2019]   [Apr]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] pinctrl: intel: save HOSTSW_OWN register over suspend/resume
On Fri, Mar 29, 2019 at 04:38:20PM +0800, Chris Chiu wrote:
> On Thu, Mar 28, 2019 at 8:34 PM Mika Westerberg
> <mika.westerberg@linux.intel.com> wrote:
> >
> > On Thu, Mar 28, 2019 at 08:19:59PM +0800, Chris Chiu wrote:
> > > On Thu, Mar 28, 2019 at 5:38 PM Daniel Drake <drake@endlessm.com> wrote:
> > > >
> > > > On Thu, Mar 28, 2019 at 5:17 PM Andy Shevchenko
> > > > <andriy.shevchenko@intel.com> wrote:
> > > > > Hmm... Can you confirm that laptop you declared as a fixed case and the
> > > > > mentioned here is the same one?
> > > >
> > > > They are definitely not the same exact unit - originally we had a
> > > > pre-production sample, and now we briefly diagnosed a real production
> > > > unit that was sold to a customer. There could be subtle motherboard
> > > > variations as you mention.
> > > >
> > > > > If it's the case, I recommend to ping Asus again and make them check and fix.
> > > >
> > > > We'll keep an eye open for any opportunities to go deeper here.
> > > > However further investigation on both our side and theirs is blocked
> > > > by not having any of the affected hardware (since the models are now
> > > > so old), so I'm not very optimistic that we'll be able to make
> > > > progress there.
> > > >
> > > > > Meanwhile, Mika's proposal sounds feasible and not so intrusive. We may
> > > > > implement this later on.
> > > >
> > > > Chris will work on implementing this for your consideration.
> > > >
> > > > Thanks for the quick feedback!
> > > > Daniel
> > >
> > > What if I modify the patch as follows? It doesn't save HOSTSW_OWN register.
> > > It just toggles the bit specifically for the IRQ GPIO pin after resume when DMI
> > > matches.
> >
> > I don't really like having quirks like this if we can avoid it and in
> > this case I think we can. Just always save HOSTSW_OWN and then restore
> > it if there is a GPIO requested and the value differs (and log a warning
> > or something like that).
>
> You mean save the content of hostsw_own register on padgroup based ex.
> communities[i].hostown[gpp] = readl(base + gpp * 4);
>
> And then check the hostown bit for the GPIO requested pin in
> intel_pinctrl_resume(),
> differs the hostsw_own bit on pin base (like padcfg), then restore the
> hostsw_own
> value of the padgroug which the GPIO pin is belonging to?

Yes.

> I think what you mean should be a much more straightforward solution
> for this. Could
> you implement this in your way and we can try to help verification. Thanks.

Sure I can but it probably does not happen until end of the week because
I'm currently busy with something else.

\
 
 \ /
  Last update: 2019-04-01 09:50    [W:0.064 / U:0.340 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site