lkml.org 
[lkml]   [2019]   [Feb]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[PATCH v4 1/9] dt-bindings: mtd: ingenic: Add compatible strings for JZ4740 and JZ4725B
    Date
    Add compatible strings to probe the jz4780-nand and jz4780-bch drivers
    from devicetree on the JZ4725B and JZ4740 SoCs from Ingenic.

    Signed-off-by: Paul Cercueil <paul@crapouillou.net>
    ---

    Changes:

    v2: - Change 'ingenic,jz4725b-nand' compatible string to
    'ingenic,jz4740-nand' to reflect driver change
    - Add 'ingenic,jz4740-bch' compatible string
    - Document 'ingenic,oob-layout' property

    v3: - Removed 'ingenic,oob-layout' property
    - Update compatible strings to what the driver supports

    v4: No change

    Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt | 10 ++++++++--
    1 file changed, 8 insertions(+), 2 deletions(-)

    diff --git a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
    index 29ea5853ca91..a5b940f18bf6 100644
    --- a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
    +++ b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
    @@ -6,7 +6,10 @@ memory-controllers/ingenic,jz4780-nemc.txt), and thus NAND device nodes must
    be children of the NEMC node.

    Required NAND controller device properties:
    -- compatible: Should be set to "ingenic,jz4780-nand".
    +- compatible: Should be one of:
    + * ingenic,jz4740-nand
    + * ingenic,jz4725b-nand
    + * ingenic,jz4780-nand
    - reg: For each bank with a NAND chip attached, should specify a bank number,
    an offset of 0 and a size of 0x1000000 (i.e. the whole NEMC bank).

    @@ -72,7 +75,10 @@ NAND devices. The following is a description of the device properties for a
    BCH controller.

    Required BCH properties:
    -- compatible: Should be set to "ingenic,jz4780-bch".
    +- compatible: Should be one of:
    + * ingenic,jz4740-ecc
    + * ingenic,jz4725b-bch
    + * ingenic,jz4780-bch
    - reg: Should specify the BCH controller registers location and length.
    - clocks: Clock for the BCH controller.

    --
    2.11.0
    \
     
     \ /
      Last update: 2019-02-09 20:25    [W:4.190 / U:0.124 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site