lkml.org 
[lkml]   [2019]   [Feb]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH V13 3/5] i2c: tegra: Add DMA support
From
Date
06.02.2019 19:38, Sowjanya Komatineni пишет:
>>>> Looking into timestamps and transactions, DMA timeouts after start of DMA for I2C1 to touch during this transaction.
>>>> While it is waiting for I2C1 DMA transfer, lots of DVC transactions
>>>> happened thru DMA which are successful
>>>>
>>>> What is the I2C1 speed?
>>>
>>> 400KHz
>>>
>>>> Also incase if device is running slow for some reason, probably timeout was not enough as this patch series changes timeout with base 100mS + msg transfer time based on transfer size.
>>>> Can you give quick try with increased timeout incase if device is running slow?
>>>>
>>>
>>> Tried to increase the timeout to 1 second, doesn't help.
>>>
>>> What helped again is the I2C HW resetting after each transfer. Likely that means that HW isn't programmed correctly, please carefully check every bit.
>>>
>>> DMA-only + I2C HW reset: http://dpaste.com/26AQXFM.txt
>>
>> Seems I found what's the problem. Here is the fix, please include it to v14 if it is correct.
>>
>> diff --git a/drivers/i2c/busses/i2c-tegra.c b/drivers/i2c/busses/i2c-tegra.c index a9391c3646b6..5ad54da70304 100644
>> --- a/drivers/i2c/busses/i2c-tegra.c
>> +++ b/drivers/i2c/busses/i2c-tegra.c
>> @@ -912,7 +912,7 @@ static irqreturn_t tegra_i2c_isr(int irq, void *dev_id) static void tegra_i2c_config_fifo_trig(struct tegra_i2c_dev *i2c_dev,
>> size_t len) {
>> - u32 val, reg;
>> + u32 val = 0, reg;
>> u8 dma_burst = 0;
>> struct dma_slave_config slv_config = {0};
>> struct dma_chan *chan;
>> @@ -922,7 +922,6 @@ static void tegra_i2c_config_fifo_trig(struct tegra_i2c_dev *i2c_dev,
>> reg = I2C_MST_FIFO_CONTROL;
>> else
>> reg = I2C_FIFO_CONTROL;
>> - val = i2c_readl(i2c_dev, reg);
> >
> > if (i2c_dev->is_curr_dma_xfer) {
> > if (len & 0xF)
>
> Thanks dmitry. Good catch. Didn't caught to my eyes. Yes FIFO_CONTROL is set based on read value without masking and oring causing back-back DMA transfers resulting in incorrect trig levels
> We can directly set trig levels.
> Will fix it.
>

Awesome!

\
 
 \ /
  Last update: 2019-02-06 17:43    [W:1.802 / U:0.544 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site