lkml.org 
[lkml]   [2019]   [Feb]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 1/9] pinctrl: sunxi: Support I/O bias voltage setting on A80
On Wed, Feb 6, 2019 at 4:32 AM Chen-Yu Tsai <wens@csie.org> wrote:

> The A80 SoC has configuration registers for I/O bias voltage. Incorrect
> settings would make the affected peripherals inoperable in some cases,
> such as Ethernet RGMII signals biased at 2.5V with the settings still
> at 3.3V. However low speed signals such as MDIO on the same group of
> pins seem to be unaffected.
>
> Previously there was no way to know what the actual voltage used was,
> short of hard-coding a value in the device tree. With the new pin bank
> regulator supply support in place, the driver can now query the
> regulator for its voltage, and if it's valid (as opposed to being the
> dummy regulator), set the bias voltage setting accordingly.
>
> Add a quirk to denote the presence of the configuration registers, and
> a function to set the correct setting based on the voltage read back
> from the regulator.
>
> This is only done when the regulator is first acquired and enabled.
> While it would be nice to have a notifier on the regulator so that when
> the voltage changes, the driver can update the setting, in practice no
> board currently supports dynamic changing of the I/O voltages.
>
> Signed-off-by: Chen-Yu Tsai <wens@csie.org>

Hi Chen-Yu,

thanks for the patch! I tried to apply it on the pinctrl devel branch
(for v5.1) but it failed to apply, I assume because it depends on
the fixes that I just sent to Torvalds.

Shall we proceed like this that I merge v5.0-rc6 as soon as it is
out and then try to apply this on top of that instead, so we get
rid of this conflict?

Yours,
Linus Walleij

\
 
 \ /
  Last update: 2019-02-06 09:15    [W:0.054 / U:22.368 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site