lkml.org 
[lkml]   [2019]   [Feb]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/9] pinctrl: sunxi: Support I/O bias voltage setting on A80
On Wed, Feb 06, 2019 at 11:32:31AM +0800, Chen-Yu Tsai wrote:
> The A80 SoC has configuration registers for I/O bias voltage. Incorrect
> settings would make the affected peripherals inoperable in some cases,
> such as Ethernet RGMII signals biased at 2.5V with the settings still
> at 3.3V. However low speed signals such as MDIO on the same group of
> pins seem to be unaffected.
>
> Previously there was no way to know what the actual voltage used was,
> short of hard-coding a value in the device tree. With the new pin bank
> regulator supply support in place, the driver can now query the
> regulator for its voltage, and if it's valid (as opposed to being the
> dummy regulator), set the bias voltage setting accordingly.
>
> Add a quirk to denote the presence of the configuration registers, and
> a function to set the correct setting based on the voltage read back
> from the regulator.
>
> This is only done when the regulator is first acquired and enabled.
> While it would be nice to have a notifier on the regulator so that when
> the voltage changes, the driver can update the setting, in practice no
> board currently supports dynamic changing of the I/O voltages.
>
> Signed-off-by: Chen-Yu Tsai <wens@csie.org>

Acked-by: Maxime Ripard <maxime.ripard@bootlin.com>

Maxime

--
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2019-02-06 13:17    [W:0.088 / U:0.116 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site