lkml.org 
[lkml]   [2019]   [Feb]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/3] mmc: sunxi: Filter out unsupported modes declared in the device tree
On Sun, Feb 03, 2019 at 11:56:27PM +0800, Chen-Yu Tsai wrote:
> The MMC device tree bindings include properties used to signal various
> signalling speed modes. Until now the sunxi driver was accepting them
> without any further filtering, while the sunxi device trees were not
> actually using them.
>
> Since some of the H5 boards can not run at higher speed modes stably,
> we are resorting to declaring the higher speed modes per-board.
>
> Regardless, having boards declare modes and blindly following them,
> even without proper support in the driver, is generally a bad thing.
>
> Filter out all unsupported modes from the capabilities mask after
> the device tree properties have been parsed.
>
> Cc: <stable@vger.kernel.org>
> Signed-off-by: Chen-Yu Tsai <wens@csie.org>
>
> ---
>
> This should be backported to stable kernels in case people try to run
> new device trees (that declare newly supported modes) with old kernels.
> ---
> drivers/mmc/host/sunxi-mmc.c | 16 ++++++++++++++++
> 1 file changed, 16 insertions(+)
>
> diff --git a/drivers/mmc/host/sunxi-mmc.c b/drivers/mmc/host/sunxi-mmc.c
> index 7415af8c8ff6..a01433012db0 100644
> --- a/drivers/mmc/host/sunxi-mmc.c
> +++ b/drivers/mmc/host/sunxi-mmc.c
> @@ -1415,6 +1415,22 @@ static int sunxi_mmc_probe(struct platform_device *pdev)
> if (ret)
> goto error_free_dma;
>
> + /*
> + * If we don't support delay chains in the SoC, we can't use any
> + * of the DDR speed modes. Mask them out in case the device
> + * tree specifies the properties for them, which gets added to
> + * the caps by mmc_of_parse() above.
> + */
> + if (!(host->cfg->clk_delays || host->use_new_timings))
> + mmc->caps &= ~(MMC_CAP_3_3V_DDR | MMC_CAP_1_8V_DDR |
> + MMC_CAP_1_2V_DDR);
> +
> + /* TODO: UHS modes untested due to lack of supporting boards */
> + mmc->caps &= ~MMC_CAP_UHS;

I've tested up to SDR104 and it works on the A64 at least

> + /* TODO: This driver doesn't support HS200 and HS400 modes yet */
> + mmc->caps2 &= ~(MMC_CAP2_HS200 | MMC_CAP2_HS400);

And HS200 works too.

Maxime

--
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2019-02-04 10:35    [W:0.143 / U:2.788 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site