lkml.org 
[lkml]   [2019]   [Feb]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH v3] net: e1000e: add MAC address kernel cmd line parameter
Date
> > Hi Andrew,
> >
> > we produce a lot of boards and we have to change the MAC address,
> > from u-boot, for every board. So I must save in the u-boot
> > environment (SPI NOR flash) the MAC address for every board.
>
> Hi Flavio
>
> u-boot should be able to write the MAC address in the correct part of
> device tree. Boards have been doing this a long time.
>
> Module parameters are considered bad. You should only do it if you
> have no other option. Here you do have another options, so it is going
> to be a hard sell getting David to access your patch.
>
> You will have more success by adding a call to
> eth_platform_get_mac_address() to the e1000e driver.

You have right, and thanks for your suggestions,
but with a kernel parameter I can use the same method
for any board where the NVM is missed, independently of any architecture
(with or without the device tree presence - ARM or x86 or others).

In fact slso the drivers/net/ethernet/freescale/fec_main.c provides
a kernel parameter for the MAC address, in fec_get_mac:

/*
* try to get mac address in following order:
*
* 1) module parameter via kernel command line in form
* fec.macaddr=0x00,0x04,0x9f,0x01,0x30,0xe0
*/
iap = macaddr;

Thanks,

Flavio

> Andrew

\
 
 \ /
  Last update: 2019-02-28 18:13    [W:0.154 / U:0.228 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site