lkml.org 
[lkml]   [2019]   [Feb]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH RFC V2 1/3] dt-bindings: hwmon: Add tachometer interrupt to pwm-fan
Date
This adds the tachometer interrupt to the pwm-fan binding, which is
necessary for RPM support.

Signed-off-by: Stefan Wahren <stefan.wahren@i2se.com>
---
Documentation/devicetree/bindings/hwmon/pwm-fan.txt | 19 +++++++++++++++++++
1 file changed, 19 insertions(+)

diff --git a/Documentation/devicetree/bindings/hwmon/pwm-fan.txt b/Documentation/devicetree/bindings/hwmon/pwm-fan.txt
index 49ca5d8..7d09623 100644
--- a/Documentation/devicetree/bindings/hwmon/pwm-fan.txt
+++ b/Documentation/devicetree/bindings/hwmon/pwm-fan.txt
@@ -8,6 +8,14 @@ Required properties:

Optional properties:
- fan-supply : phandle to the regulator that provides power to the fan
+- interrupts : This contains a single interrupt specifier which
+ describes the tachometer output of the fan as an
+ interrupt source. The output signal must generate a
+ defined number of interrupts per fan revolution, which
+ require that it must be self resetting edge interrupts.
+ See interrupt-controller/interrupts.txt for the format.
+- interrupt-ratio : defines the ratio interrupts per fan revolution as an
+ integer (default is 2 interrupts per revolution)

Example:
fan0: pwm-fan {
@@ -38,3 +46,14 @@ Example:
};
};
};
+
+Example 2:
+ fan0: pwm-fan {
+ fan0: pwm-fan {
+ compatible = "pwm-fan";
+ pwms = <&pwm 0 40000 0>;
+ fan-supply = <&reg_fan>;
+ interrupt-parent = <&gpio5>;
+ interrupts = <1 IRQ_TYPE_EDGE_FALLING>;
+ interrupt-ratio = <2>;
+ };
--
2.7.4
\
 
 \ /
  Last update: 2019-02-25 17:01    [W:0.056 / U:0.148 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site