lkml.org 
[lkml]   [2019]   [Feb]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v4 8/8] phy: ufs-qcom: Refactor all init steps into phy_poweron
From
Date
Quoting Evan Green (2019-02-13 15:25:26)
> The phy code was using implicit sequencing between the PHY driver
> and the UFS driver to implement certain hardware requirements.
> Specifically, the PHY reset register in the UFS controller needs
> to be deasserted before serdes start occurs in the PHY.
>
> Before this change, the code was doing this by utilizing the two
> phy callbacks, phy_init() and phy_poweron(), as "init step 1" and
> "init step 2", where the UFS driver would deassert reset between
> these two steps.
>
> This makes it challenging to power off the regulators in suspend,
> as regulators are initialized in init, not in poweron(), but only
> poweroff() is called during suspend, not exit().
>
> For UFS, move the actual firing up of the PHY to phy_poweron() and
> phy_poweroff() callbacks, rather than init()/exit(). UFS calls
> phy_poweroff() during suspend, so now all clocks and regulators for
> the phy can be powered down during suspend.
>
> QMP is a little tricky because the PHY is also shared with PCIe and
> USB3, which have their own definitions for init() and poweron(). Rename
> the meaty functions to _enable() and _disable() to disentangle from the
> PHY core names, and then create two different ops structures: one for
> UFS and one for the other PHY types.
>
> In phy-qcom-ufs, remove the 'is_powered_on' and 'is_started' guards,
> as the generic PHY code does the reference counting. The
> 14/20nm-specific init functions get collapsed into the generic power_on()
> function, with the addition of a calibrate() callback specific to 14/20nm.
>
> Signed-off-by: Evan Green <evgreen@chromium.org>
> ---

Reviewed-by: Stephen Boyd <swboyd@chromium.org>

\
 
 \ /
  Last update: 2019-02-22 21:29    [W:0.059 / U:0.060 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site