lkml.org 
[lkml]   [2019]   [Feb]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/5] serial: sprd: Modify the baud rate calculation formula
Date
From: Lanqing Liu <lanqing.liu@unisoc.com>

When the source clock is not divisible by the expected baud rate and
the remainder is not less than half of the expected baud rate, the old
formular will round up the frequency division coefficient. This will
make the actual baud rate less than the expected value and can not meet
the external transmission requirements.

Thus this patch modifies the baud rate calculation formula to support
the serial controller output the maximum baud rate.

Signed-off-by: Lanqing Liu <lanqing.liu@unisoc.com>
Signed-off-by: Baolin Wang <baolin.wang@linaro.org>
---
drivers/tty/serial/sprd_serial.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/tty/serial/sprd_serial.c b/drivers/tty/serial/sprd_serial.c
index 4287ca3..1891a45 100644
--- a/drivers/tty/serial/sprd_serial.c
+++ b/drivers/tty/serial/sprd_serial.c
@@ -371,7 +371,7 @@ static void sprd_set_termios(struct uart_port *port,
/* ask the core to calculate the divisor for us */
baud = uart_get_baud_rate(port, termios, old, 0, SPRD_BAUD_IO_LIMIT);

- quot = (unsigned int)((port->uartclk + baud / 2) / baud);
+ quot = port->uartclk / baud;

/* set data length */
switch (termios->c_cflag & CSIZE) {
--
1.7.9.5
\
 
 \ /
  Last update: 2019-02-19 08:33    [W:0.066 / U:0.792 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site