lkml.org 
[lkml]   [2019]   [Feb]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 1/2] leds: Add Intel Cherry Trail Whiskey Cove PMIC LEDs

> >I don't pretend to fully understand it, _but_ hw_pattern should really
> >describe the pattern LED should do, not whether it reacts to charging
> >or not.
>
> Then we are back to step 1 of the discussion, that we need another
> mechanism outside of the trigger to select if the LED shows the configured
> pattern always, or only when the charger is on.

Yep, sorry.

> These really are 2 orthogonal settings, there is a pattern which can
> be set and the LED can either show that pattern always; or only when
> charging the battery. Note that the same pattern is used in both cases.
>
> This is why I previously suggested having a custom sysfs hardware_control
> attribute which selects between the "only show pattern when charging"
> modes ("hardware_control=1" or "always show the pattern mode"
> ("hardware_control=0").

I see... and yes, that would be the easiest solution.

But somehow I see "this LED is controlled by charging state" as
primary and "it shows pulses instead of staying on" as secondary
eye-candy.

This week there was another driver for charger LED.. but that one does
not do pulses. Ideally, we'd like consistent interface to the
userland.

(To make it complex, the other driver supports things like:
LED solid on -- fully charged
LED blinking slowly -- charging
LED blinking fast -- charge error
LED off -- not charging).

Best regards,

Pavel
--
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2019-02-17 01:09    [W:0.116 / U:0.340 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site