lkml.org 
[lkml]   [2019]   [Feb]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4 2/4] dt-bindings: gnss: add mediatek binding
On Wed, Feb 13, 2019 at 04:09:27PM +0100, Loys Ollivier wrote:
> Add binding for Mediatek-based GNSS receivers.
>
> Signed-off-by: Loys Ollivier <lollivier@baylibre.com>
> ---
> v4:
> Use standard names for reset-gpios and gnss-fix-gpios
> s/an/a UART
>
> v3:
> Removed the I2C and SPI interfaces references.
> Removed the "mediatek,mt3339" compatible line.
> Added the optional propertied (reset, fix)
> Added the pin names for the optional properties.
>
> v2:
> Renamed bindings from Globaltop/gtop to Mediatek/mtk.
> Moved current-speed as an optional propertie.
> Removed the status line in the example.
> Added "mediatek,mt3339" compatible.
>
> .../devicetree/bindings/gnss/mediatek.txt | 37 ++++++++++++++++++++++
> 1 file changed, 37 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/gnss/mediatek.txt
>
> diff --git a/Documentation/devicetree/bindings/gnss/mediatek.txt b/Documentation/devicetree/bindings/gnss/mediatek.txt
> new file mode 100644
> index 000000000000..12283d429baa
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/gnss/mediatek.txt
> @@ -0,0 +1,37 @@
> +Mediatek-based GNSS Receiver DT binding
> +
> +Mediatek chipsets are used in GNSS-receiver modules produced by several
> +vendors and can use a UART interface.
> +
> +Please see Documentation/devicetree/bindings/gnss/gnss.txt for generic
> +properties.
> +
> +Required properties:
> +
> +- compatible : Must be
> +
> + "globaltop,pa6h"
> +
> +- vcc-supply : Main voltage regulator (pin name: VCC)
> +
> +Optional properties:
> +
> +- current-speed : Default UART baud rate
> +- gnss-fix-gpios : GPIO used to determine device position fix state
> + (pin name: FIX, 3D_FIX)
> +- reset-gpios : GPIO used to reset the device
> + (pin name: RESET, NRESET)
> +- timepulse-gpios : Time pulse GPIO (pin name: PPS1, 1PPS)
> +- v-bckp-supply : Backup voltage regulator
> + (pin name: VBAT, VBACKUP)

As we discussed, I changed this to "vbackup-supply" (here and in the
driver) before applying.

Note that git reported some whitespace errors above too (spaces before
tabs) that I fixed up. Not sure why checkpatch doesn't complain.

All now applied.

Thanks,
Johan

\
 
 \ /
  Last update: 2019-02-15 17:06    [W:0.111 / U:0.640 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site