Messages in this thread | | | Subject | Re: [PATCH 0/4] Add nvmem support on STM32 | From | Srinivas Kandagatla <> | Date | Wed, 13 Feb 2019 10:34:19 +0000 |
| |
On 13/02/2019 10:15, Fabrice Gasnier wrote: > On 1/30/19 5:38 PM, Fabrice Gasnier wrote: >> Non volatile memory area is available on STM32. It contains various >> factory programmed information such as unique device ID, analog calibration... >> This patchset adds NVMEM support to access these data. > > Hello, > > Gentle reminder for this new driver review Nvmem provider driver itself looks fine for me, but I am unable to take this as 5.1 material, as I normally take nvmem patches which are reviewed and ready before rc5.
dt bindings patch needs an ack from DT maintainers.
Thanks, srini > > Best Regards, > Fabrice > >> >> Fabrice Gasnier (4): >> dt-bindings: nvmem: Add STM32 factory-programmed romem >> nvmem: Add driver for STM32 factory-programmed read only mem >> nvmem: stm32: add support for STM32MP15 BSEC to control OTP data >> ARM: dts: stm32: Add romem and temperature calibration on stm32mp157c >> >> .../devicetree/bindings/nvmem/st,stm32-romem.txt | 31 ++++ >> arch/arm/boot/dts/stm32mp157c.dtsi | 13 ++ >> drivers/nvmem/Kconfig | 10 + >> drivers/nvmem/Makefile | 2 + >> drivers/nvmem/stm32-romem.c | 202 +++++++++++++++++++++ >> 5 files changed, 258 insertions(+) >> create mode 100644 Documentation/devicetree/bindings/nvmem/st,stm32-romem.txt >> create mode 100644 drivers/nvmem/stm32-romem.c >>
| |