lkml.org 
[lkml]   [2019]   [Feb]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 3/9] irq/irq_sim: provide irq_sim_fire_type()
On Tue, Feb 12, 2019 at 10:27:54AM +0000, Marc Zyngier wrote:
> On 12/02/2019 09:19, Bartosz Golaszewski wrote:
> > When userspace wants to monitor GPIO line interrupts, the GPIO
> > framework requests a threaded interrupt with IRQF_TRIGGER_FALLING,
> > IRQF_TRIGGER_RISING or both. The testing module tries to act like real
> > hardware and so if we pass only one of the *_TRIGGER_* flags, we want
> > the simulated interrupt of corresponding type to be fired.
>
> Well, that's not how HW works.

I cannot follow. I agree with Bartosz here. If you configure your SoC's
irq-controller to only fire on a raising edge, you don't get an event
when the line falls.

> > Another solution - if you don't like this one - would be to have more
> > specialized functions: irq_sim_fire_rising() and
> > irq_sim_fire_falling(). How about that?
>
> I think you're missing the point. So far, your API has been "an
> interrupt has fired", no matter what the trigger is, and that's fine.
> That's just modeling the output of an abstract interrupt controller into
> whatever the irqsim is simulating.
>
> Now, what you're exposing is "this is how the line changed". Which is an
> entirely different business, as you're now exposing the device output
> line. Yes, you can model it with raising/falling, but you need at least
> resampling for level interrupts, and actual edge detection (raising
> followed by raising only generates a single interrupt, while
> raising-falling-raising generates two).

This matches my concern and that's why I suggested somewhere else in
this thread to put the configuration of the sensitiveness and the actual
tracking of the line in the same component (either irqsim or
gpio-mockup). Given that there are only two irqsim users and the other
one (something in iio) doesn't need that sensitiveness stuff (and I
cannot imagine another user of irqsim with the sensitiveness support) I
think it is best to move this to the mockup driver. That's how "normal"
hardware drivers have to do it, too.

Best regards
Uwe

--
Pengutronix e.K. | Uwe Kleine-König |
Industrial Linux Solutions | http://www.pengutronix.de/ |

\
 
 \ /
  Last update: 2019-02-12 12:06    [W:0.056 / U:30.304 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site