lkml.org 
[lkml]   [2019]   [Feb]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 3/8] ARM: davinci: omapl138-hawk: use gpio lookup entries for usb gpios
Date
From: Bartosz Golaszewski <bgolaszewski@baylibre.com>

Add lookup entries for the vbus and overcurrent gpios for omapl138-hawk.

Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
---
arch/arm/mach-davinci/board-omapl138-hawk.c | 10 ++++++++++
1 file changed, 10 insertions(+)

diff --git a/arch/arm/mach-davinci/board-omapl138-hawk.c b/arch/arm/mach-davinci/board-omapl138-hawk.c
index 94c4f126ef86..856c5707bae9 100644
--- a/arch/arm/mach-davinci/board-omapl138-hawk.c
+++ b/arch/arm/mach-davinci/board-omapl138-hawk.c
@@ -302,6 +302,14 @@ static const short da850_hawk_usb11_pins[] = {
-1
};

+static struct gpiod_lookup_table hawk_usb_gpio_lookup = {
+ .dev_id = "ohci-da8xx",
+ .table = {
+ GPIO_LOOKUP("davinci_gpio", DA850_USB1_VBUS_PIN, "vbus", 0),
+ GPIO_LOOKUP("davinci_gpio", DA850_USB1_OC_PIN, "oc", 0),
+ },
+};
+
static int hawk_usb_set_power(unsigned port, int on)
{
gpio_set_value(DA850_USB1_VBUS_PIN, on);
@@ -390,6 +398,8 @@ static __init void omapl138_hawk_usb_init(void)
goto usb11_setup_oc_fail;
}

+ gpiod_add_lookup_table(&hawk_usb_gpio_lookup);
+
ret = da8xx_register_usb11(&omapl138_hawk_usb11_pdata);
if (ret) {
pr_warn("%s: USB 1.1 registration failed: %d\n", __func__, ret);
--
2.20.1
\
 
 \ /
  Last update: 2019-02-11 11:38    [W:0.211 / U:4.168 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site