lkml.org 
[lkml]   [2019]   [Feb]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 0/8] drm/meson: Add support for HDMI2.0 4k60
From
Date
On 31.01.2019 16:50, Neil Armstrong wrote:
> On 31/01/2019 15:13, Andrzej Hajda wrote:
>> On 31.01.2019 14:25, Neil Armstrong wrote:
>>> Hi Andrzej, Laurent,
>>>
>>> On 15/01/2019 13:33, Neil Armstrong wrote:
>>>> This patchset aims to add support for the following HDMI2.0 4k60 modes:
>>>> - 594Mhz TMDS frequency needing TMDS Scramling and 1/40 rate for RGB/YUV4:4:4
>>>> - 297MHz TMDS frequency with YUV4:2:0 encoding
>>>>
>>>> The first mode uses the SCDC helpers introduced by intel to :
>>>> - discover where the monitor support SCDC
>>>> - setup the SCDC parameters
>>>> This is implemented in the dw-hdmi bridge driver by handling scrambling
>>>> support during the bridge setup and by exporting an helper for the PHY
>>>> setup to setup the SCDC configuration for the 1/40 TMDS rate.
>>>> This code will only be active if the encoder support a TMDS rate > 340MHz.
>>>>
>>>> This patch could eventually break support on different SoC when connected
>>>> on a 4k60 monitor with SCDC :
>>>> - i.MX correctly discards pixel clocks > 216MHz
>>>> - R-CAR discards discards pixel clocks > 297MHz since [1]
>>>> - Rockchip discards invalid pixel clocks not in the rockchip_mpll_cfg table
>>>> - sun8i correctly discards pixel clocks > 297MHz on a83t
>>>> - sun8i discards discards pixel clocks > 594Mhz on h6, which is already broken
>>>>
>>>> First patch should fix support for Allwinner H6.
>>>>
>>>> The second mode is implemented by added the missing 4:2:0 bypass handling
>>>> in the dw-hdmi bridge driver and adding a "mtmdsclock" separating the
>>>> pixel clock from the tmds clock in the mode setup phase.
>>>> We also enable support for these modes in the connector only if the platform
>>>> glue code explicits the support.
>>> Do you think patches 1-4 could be applied ?
>>
>> For me they are OK.
>>
>> Should I take them via drm-misc?
> OK for me !
>
> Neil


These patches do not apply. Could you rebase them on drm-misc-next.


Regards

Andrzej



>
>>
>>> Then we could focus on how we manage the bus format between the encoder
>>> and the bridge ?
>>>
>>> Especially patch 5 linked to patch 7.
>>>
>>> Will one of you be at FOSDEM 2019 ? we could chat about this.
>>
>> Nope.
>>
>>
>> Regards
>>
>> Andrzej
>>
>>
>>> Following subjects on the table will be :
>>> - HDR metadata transmission aligned with the last patchset sent by intel-gfx
>>> - Colorspace connector property aligned with the last patchset sent by intel-gfx
>>> - HDCP 1.4 and 2.2 handling
>>>
>>> Neil
>>>
>>>> Only the meson DRM dw_hdmi glue allows ycbcr420 modes, so no breakage
>>>> is expected here.
>>>>
>>>> The remaining patches adds support for :
>>>> - 1/40 TMDS rate aka DIV40 in the dw-hdmi meson PHY setup
>>>> - 4:2:0 output and clock setup
>>>>
>>>> The dw-hdmi support re-uses the support done by Rockchip engineers on the
>>>> Linux 4.4 BSP kernel.
>>>>
>>>> These modes has been validated using a MuxLab HDMI Signal Analyser in
>>>> addition to different UHD TVs supporting full 4k60 or the 4:2:0 variant.
>>>>
>>>> Changes since RFC v2 at [3]:
>>>> - Collected tested-by and reviewed-by tags
>>>> - Changed if condition in "add HDMI div40 TMDS mode"
>>>> - Updated "Add YUV420 output support" with the same if condition
>>>>
>>>> Changes since RFC v1 at [2]:
>>>> - Fix all comments from Laurent :
>>>> - Add define for HDMI 1.4 max tmds clock and SCDC supported version
>>>> - Call dw_hdmi_set_high_tmds_clock_ratio() in dw_hdmi_phy_enable_powerdown()
>>>> to unbreak Allwinner H6
>>>> - Pass in_t(u8, bytes, SCDC_MIN_SOURCE_VERSION) as SCDC version
>>>> - Finally add comments for SCDC and Scrambling process
>>>>
>>>> [1] https://patchwork.freedesktop.org/patch/263616/
>>>> [2] https://patchwork.freedesktop.org/series/52950/#rev1
>>>> [3] https://patchwork.freedesktop.org/series/52950/#rev2
>>>>
>>>> Neil Armstrong (7):
>>>> drm/bridge: dw-hdmi: Add SCDC and TMDS Scrambling support
>>>> drm/meson: add HDMI div40 TMDS mode
>>>> drm/meson: add support for HDMI2.0 2160p modes
>>>> drm/bridge: dw-hdmi: add support for YUV420 output
>>>> drm/bridge: dw-hdmi: allow ycbcr420 modes for >= 0x200a
>>>> drm/meson: Add YUV420 output support
>>>> drm/meson: Output in YUV444 if sink supports it
>>>>
>>>> Zheng Yang (1):
>>>> drm/bridge: dw-hdmi: support dynamically get input/out color info
>>>>
>>>> drivers/gpu/drm/bridge/synopsys/dw-hdmi.c | 182 +++++++++++++++++++---
>>>> drivers/gpu/drm/bridge/synopsys/dw-hdmi.h | 1 +
>>>> drivers/gpu/drm/meson/meson_dw_hdmi.c | 128 ++++++++++++---
>>>> drivers/gpu/drm/meson/meson_vclk.c | 93 ++++++++---
>>>> drivers/gpu/drm/meson/meson_vclk.h | 7 +-
>>>> drivers/gpu/drm/meson/meson_venc.c | 8 +-
>>>> drivers/gpu/drm/meson/meson_venc.h | 11 ++
>>>> drivers/gpu/drm/meson/meson_venc_cvbs.c | 3 +-
>>>> include/drm/bridge/dw_hdmi.h | 7 +
>>>> 9 files changed, 374 insertions(+), 66 deletions(-)
>>>>
>>>
>> _______________________________________________
>> dri-devel mailing list
>> dri-devel@lists.freedesktop.org
>> https://lists.freedesktop.org/mailman/listinfo/dri-devel
>>
>
>

\
 
 \ /
  Last update: 2019-02-01 11:26    [W:1.923 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site